N26704 2100w metal cut off saw instruction manual after sales support tel: 1300 922 271 email: service.Australia@einhell.Com model number bt-mc 355.
Metal cut off saw what your 1 year warranty means great care has gone into the manufacture of this product and it should therefore provide you with years of good service when used properly. In the event of product failure within its intended use over the once it has been brought to our attention. In...
1 4 2 b 10 9 2 3 16 11 5 8 7 5 6 14 6 1 3 7 2 b 15 13 17 12 a 15 4 after sales support email: service.Australia@einhell.Com tel: 1300 922 271 2.
5 6 8 1 16 7 4 15 17 4 19 18 13 7 3 20 21 11 24 9 11 23 24 22 7 10 b 9 1 11 10 15 2 21 9 after sales support email: service.Australia@einhell.Com tel: 1300 922 271 3.
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to rotating part of the power tool may result in personal injury. E. Do not overreach. Keep proper footing and balance at...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 2. Special safety rules 1. For your own safety, read these safety instructions before you put the electric tool into operation. Familiarize yourself with the tools operating range and limits, as well as the special hazards in...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 34. Allow the motor to reach top speed before you begin to cut. 35. After you have switched on, lower the cut-off wheel slowly until it comes into contact with the workpiece. Then carry out a smooth cut. Avoid causing the cut...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 4. Items supplied • metal cut-off saw • 2x cut-off wheel • open-ended wrench • instruction manual • quick start guide • warranty card and details • warranty sticker 5. Proper use the metal cut-off machine is designed for cutt...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 • release the (fig.2/item 13) locking device. 8. Assembly important. Always pull out the power plug before carrying out maintenance, resetting or assembly work. 8.1 transport brace / carry-handle (fig. 1 / 2) • push saw head ...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 phase, the appliance can be switched back on by pressing the overload switch (14) 9.3 making a cut (fig. 9) • clamp the workpiece securely in the vice (15). • switch on the machine and wait for the motor to reach its top spee...
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 10
After sales support email: service.Australia@einhell.Com tel: 1300 922 271 08/2012 45.031.29_11012(01) 11.
