Taurus TST16 355 Operating Instructions Manual - page 6
Manual is about: METAL CUT OFF SAW
of
17
Loosen and Tighten the vice
Tighten
Turn the vice rod clockwise to secure the work-piece with the vice.
Loosen
Turn the vice rod anti-clockwise to release the work-piece (see Figure 1).
•
When a large work-piece is to be processed, move the auxiliary stopper
forward 3.5 mm (see Figure 2).
•
Raise the section bar with a supporting block, if you want to continuously
use a worn abrasive wheel. Check the size of the supporting block first.
Ensure that it is smaller than the size of the section bar, so that the section
bar can be secured by the vice.
Figure 2
Figure 1
3.5mm
Supporting Block