Taurus TT-CW 18 Li Instruction Manual - And Ordering Of Spare
13
After Sales Support
EMAIL: service.australia@einhell.com
TEL: 1300 922 271
4.7.5 Loosening screws
For as long as the screw is tightened, the tool works as a
impact driver. As soon as the screw is loosened, the tool
operates as a normal screwdriver.
4.8 CLEANING, MAINTENANCE
AND ORDERING OF SPARE
PARTS
Always pull out the mains power plug before starting any
cleaning work.
4.8.1 Cleaning
•
Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible.
•
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
•
We recommend that you clean the device immediately
each time you have finished using it.
•
Clean the equipment regularly with a moist cloth and
some soft soap. Do not use cleaning agents or solvents;
these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device.
4.8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
4.8.3 Ordering replacement parts
Contact our After Sales Support on 1300 922 271 and quote
the following data when ordering spare parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Spare part number of the part required
4.9 DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent it from being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Contact your dealer or your local council for
disposal requirements.
4.10 STORAGE
Store the equipment and accessories out of children’s
reach in a dark and dry place at room temperature. Never
store the unit below 0 °C. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.