Taurus TTA-10951 Instruction Manual - page 10
Manual is about: 150w
of
12
Removing or Changing the Grinding Wheels
To remove or change the grinding wheels, perform the following steps:
1.
Disconnect the power supply cord.
2.
R
emov
e
the outside covers left and right.
3.
Holding the grinding wheel firmly, remove the nut and flange from the shaft with a
spanner. Note that the left wheel nut has a left hand thread and the right wheel nut
has a right hand thread.
4.
Remove the old wheel and replace it with the new wheels.
5.
Re-assemble the flange, nut and outside covers.
6.
Allow the grinder to run for one minute to ensure the grinding wheel is not out of
balance before commencing any grinding work.
After Sales Support Tel: 1300-355-255
9