TAZ TAZ Quick Start Manual - page 4
No
te:
Make sure your printer work space is
clear of anything that could obstruct the
movement of the printer, and that there
are no flammable fabrics or liquids near
the printer surface. Avoid placing your
printer near a drafty window or air
conditioner vent.
The top most connector matches the large straight plug
from the XZ cable. The next connector down matches the
large angled plug from the YZ cable. The third connector
matches the smallest plug, from the heated bed cable.
Buy printers, parts and plastics at
LulzBot.com
Attaching the Power Supply
Locate and unwrap the power supply, USB cables,
and AC power cable.
Make sure the power supply is
completely unplugged before moving on to the
next step.
Change the AC input switch to 110V or
220V, depending on your regional AC voltage standard.
The switch is located on the side of the power supply.
9
Locate the blue 24VDC output cable plug from
the power supply. Connect the blue power
supply plug into the keyed power supply
connector on the TAZ electronics enclosure.
Once the plug is pushed in completely, turn the locking
sleeve clockwise until it is tight against the electronics
enclosure.
10
Locate the USB plug on the front of the TAZ
electronics enclosure. Plug in the USB cable,
square B plug end, into the USB receptacle on
the front of the electronics enclosure. Plug the
A end of the USB cable into your computer.
12
Attaching the Filament Guide
Locate the filament guide with attached PTFE
tube. The filament guide easily attaches to the
filament guide mount on the top right side of
the printer frame.
13
Before printing, familiarize yourself
with the TAZ cartesian type system
A
The printer moves in three axes: X, Y, and Z.
These three axes allow the tool head to move
to any point within the print area. Note the
location of the mechanical end stops, which are
small switches at the home point of each axis. Each end
stop switch allows the printer to find the home, or
starting point, of each axis.
14
Check that all four
plugs are inserted
into the correct
connector. Use the
image to the right to
reference how the rear of
the electronics should
appear with all four plugs
connected.
Check that the locking
sleeve of each connector is
firmly hand tightened.
11