TBK TBK-BUL4700EIR36 Operating Instructions Manual - page 10
19
Programming the camera ID:
1. Press the LEFT or RIGHT key to turn On the Camera Title mode.
2. While Camera ID function is On, press the SET key to enter the sub-menu.
3. Using the directional navigation keys, choose from alphabetical letters and numbers
to create a 15-digit Camera ID.
4. Move the cursor to POS and press the SET key.
The Camera ID will appear on the bottom center.
5. Using the directional navigation keys, change the position of the Camera Title to the
desired location.
6. Move the cursor to END, then press the SET key to save and exit.
●
DAY & NIGHT : AUTO, COLOR, B/W, EXT
This function is used to control the color setting during daytime and night-time
operation.
> AUTO : The Color mode is operated during daytime and automatically converts to
B/W mode in the absence of light during night-time.
AGC cannot be modified in this mode.
D
→ N Level –
This level determines the level of darkness before switching from Day mode to
Night mode.
D
→ N Delay –
This function is used to set the delay between switching of the modes.
If the delay has been set to ‘3’, the camera will observe darkness for at least
3 seconds before switching to Night mode.
N
→ D Level – Opposite of D → N Level.
N
→ D Delay – See above D → N Delay.
> COLOR: The camera is always in Color mode.
> B/W: The camera is always in B/W mode.
BRUST OFF - This function smooths out noise in BW mode.
OSD Menu Instructions
20
BURST ON - This function makes the transition between switching of the modes
smoother when Color turns to BW.
IR SMART (ON/OFF) – This function detects too much IR reflection and automatically
compensates for the over exposure. Specific area can be defined by adjusting the
location and size of the detection grid.
IR LEVEL (HIGH/LOW) – This function is used to higher or lower the IR LED intensity.
> EXT: This feature is not supported.
●
MOTION : ON, OFF
This function is used to detect motion in the monitored area.
The “Running Man” icon will be displayed on the bottom left corner once motion has
been detected. There are 4 pre-defined white boxes representing the areas monitored
for motion. Each boxes van be individually adjusted to user preference.
> AREA SEL. (AREA1~4): Choose one of four pre-defined boxes to adjust its size or
location.
> AREA STATE (ON,OFF) : Select a box active or inactive for motion detection.
> HEIGHT, WIDTH: Adjust the height or width of the area.
> LEFT/RIGHT, TOP/BOTTOM: Changes the location of the defined area.
> DEGREES (0~255): Increase or decrease the sensitivity of the selected area.
Increasing the number decreases sensitivity.
> VIEW (ON,OFF): Truns the “Running Man” indication On or Off.
> RETURN: Select RET to save and exit, and to go back to the MAIN MENU.
●
PRIVACY : ON, OFF
This function is used to mask specific areas within the frame of the camera to be
concealed. There are total of 8 different colored boxes representing the masked areas.
Each boxes can be individually adjusted to user preference.
OSD Menu Instructions