TBK Vision RYK2611 Instruction Manual - 2. Installation
P.2
2. INSTALLATION
STEP 1:Select a location in the ceiling where you want to install the camera
unit.
STEP 2:Connect the cables as follows: 12V DC to A , Video Out to B .(Ref.
Figure 1)
STEP 3:With your hand, position the camera unit so the camera is aimed
toward the area to be observed.
STEP 4:While holding the unit in position, re-check the camera's horizontal
sighting to ensure the unit's position is correct as placed in Step 1.
(Ref. Figure 1)
STEP 5:If it is necessary to adjust the vertical view angle, do the following -
Loosen screw D with a screwdriver. Turn the Camera Board C to the
desired angle (you may use a portable monitor or communicate with
the Master Control Room to make sure the view angle is correct).
Tighten screw D to secure the vertical view angle. (Ref. Figure 1)
Figure 1 ( Steps 1 through 5 )