Hi-speed dome camera outdoor housing instruction manual outdoor housing.
Rev 1.2 2 warning & caution general features names of each part a. Basic parts b. Accessories installation a. Wall mount bracket b. Pipe mount bracket c. Gooseneck mount bracket d. Corner mount adaptor e. Pole mount adaptor fan / heater specification contents 3 3 4 4 5 6 6 7 8 9 9 10 11.
Rev 1.2 3 if you fail to read this information and handle the product incorrectly, death or serious injury may occur. 1. Outdoor housing 2. Wall mount bracket screw (m4x16 screw 5ea) 4. Manual 5. Cable ties ( 5 ea) 6. Wrench ( 1 ea) 7. Screws (m3 x 6) 2ea 8. Screws (m3.5 x 22) 2ea the unit should be...
Rev 1.2 4 a. Basic parts 1. Wall mount bracket 2. Sun-visor 3. Housing 4. Bubble 5. Ceiling mount bracket for indoor camera 6. Fan 7. Heater 8. Circuit board 9. Pipe mount bracket name of each part 1 2 4 3 5 6 7 8 fig.1 9.
Rev 1.2 5 b. Additional accesorries name of each part tb-105 – pipe mount bracket tb-106 – goose neck mount bracket tb-107 – corner mount adaptor tb-109 – pole mount adaptor.
Rev 1.2 6 a. Wall mount bracket a-1 . To install wall mount bracket tip select a ceiling board strong enough to hold 4 times the total weight of the camera (weight combined camera : approx.5kg) a-2. Screw up the bracket tightly using the wrench (m4.0) after putting the rising into the hole. A-3. Scr...
Rev 1.2 7 b. Pipe mount bracket b-1. Wind the seal tape around the tap of pipe and screw down the housing. B-2. Put silicon sealant into the connection part. B-3. Rotate the pipe and fix to the ceiling bracket. Silicon sealant thread seal tape fig.5 fig.6 installation.
Rev 1.2 8 c. Gooseneck mount bracket c-1. Wind the seal tape around the tap of pipe and screw down the housing. C-2. Put silicon sealant into the connection part. C-3. Rotate the pipe and fix to the ceiling bracket. Thread seal tape fig.7 silicon sealant fig.8 installation.
Rev 1.2 9 d. Corner mount adaptor d-1. Install a corner mount adaptor on the corner of wall. D-2. Install fixable brackets (wall, gooseneck) with a corner mount adaptor e. Pole mount adaptor e-1. Install a pole mount adaptor on the pole. Installation.
Rev 1.2 10 e-2. Install fixable brackets (wall, gooseneck) with a pole mount adaptor joint with adaptor or dome camera power heater fan ac24v 1a fig.7 fan / heater fig 11.
Rev 1.2 11 model outdoor housing temperature for heater working on: below 10 , off: over 15 temperature for fan working on: over 45 , off: below 35 temperature range of use -40 ℃ ~ +60 humidity range of use below 90% waterproof capacity ip 66 construction poly carbonate (glass), aluminum (body) dime...
Rev 1.2 12.