TC Electronic BG500/115 User Manual - Miscellaneous
Ventilation
Be sure not to cover the BG500 cooling grid!
Insufficient ventilation may cause the amplifier’s temperature to
increase to critical values.
Protection Modes
The BG500 Combo is equipped with an intelligent protection
system, ensuring that the amp does not suffer or malfunction if
operated wrongly or in extreme environments.
General Protection Mode
When the BG500 Combo switches to
Protection
mode, the
MUTE LED is lit while the first two and last two Compression
LEDs light up in turn.
Protection mode is invoked when (for whatever reason) a short
circuit situation occurs. In Protection mode, the speaker outputs
are shut off to prevent speaker damage. However, the balanced
output passes audio even in Protection mode.
To remedy the problem, try turning off the BG500 Combo for a
minute and then back on again. If the LED pattern described
here shows again, you will have to send the BG500 Combo to a
qualified service center for inspection.
Heat Protection Mode
When the BG500 Combo switches to
Heat Protection
mode, the
PEAK and MUTE LEDs are lit while the first two and last two
Compression LEDs light up in turn.
Heat Protection is invoked if the amplifier is used in an
environment that is too hot, or if proper ventilation is not
ensured.
Proceed as follows:
–
Turn off the amplifier.
–
Solve the issues.
–
Allow the amplifier to cool off for a few minutes.
–
Turn on the amplifier again.
MISCELLANEOUS
13
EN