TC Electronic DARK MATTER User Manual

Summary of DARK MATTER

  • Page 1

    User’s manual.

  • Page 2

    2 important safety instructions 1 read these instructions. 2 keep these instructions. 3 heed all warnings. 4 follow all instructions. 5 do not use this apparatus near water. 6 clean only with dry cloth. 7 do not block any ventilation openings. Install in accor- dance with the manufacturer’s instruct...

  • Page 3

    3 these limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy and – if not installed and used in accordance with the instructions – may cause harmful interference to radio ...

  • Page 4: (En) Introduction

    4 www.Tcelectronic.Com - www.Youtube.Com/tcelectronic (en) introduction congratulations! You have just bought a distortion pedal that personifies rock and represents all that is good about distorted tones. This pedal will inspire your riffs, licks and leads for years to come. This pedal defines inst...

  • Page 5

    5 1 - effect on/off (true bypass) 2 - 1/4 inch mono jack input 3 - 1/4 inch mono jack output 4 - bass control 5 - treble control 6 - gain control 7 - level control 8 - voice selector 9 - power in (9vdc).

  • Page 6: Connecting

    6 connecting input jack – 1/4 inch mono jack input. If you run the pedal on battery, we recommend removing the input jack to preserve battery power when you don’t play. Output jack – 1/4 inch mono jack output for connecting to another pedal or directly into an amp or mixer. Power in – use a 9 vdc po...

  • Page 7: The Controls

    7 the controls bass & treble bass/treble controls. Add bass for more punch or roll off a bit for a tighter sound on big cabinets. Add treble to cut through a dense mix or reduce to aim for a softer tone. Gain controls the amount of gain. Lower settings give tight distortion for rhythm parts. Higher ...

  • Page 8

    8 changing battery – unscrew the thumb-screw on the back of the pedal and detach the back-plate. Unmount the old battery and attach the new battery to the battery clip making sure the polarity is correct. Then remount the back-plate. To save battery life, remove the input jack when you don’t play. B...

  • Page 9

    9 unique distortion circuit with classic tube-amp characteristics: high headroom, low compression and amazing bottom-end touch sensitive – control tone and distortion level by pick attack and your guitars volume knob two-band active eq with separate bass and treble controls voice switch for vintage ...

  • Page 10

    Tc electronic, sindalsvej 34, dk-8240 risskov info@tcelectronic.Com.