TC Electronic NonLin2 Manual - Focus Fields
EE
NN
GG
LL
II
SS
HH
6 /
NonLin2
FOCUS FIELDS
You can place your own set of parameters in the 6 focus fields at the bottom of the
plug-in. Making use of the focus fields can give you a better workflow, since you will
not have to switch pages all the time to find the parameters that you work with. You
can assign any parameter to the focus fields, and the focus fields are stored with the
session as well as when you save your presets.
To change the assignment:
• Press the Assign button. The Assign button as well as one of the Focus Fields
will be highlighted.
• Select the Focus Field you wish to link a parameter to, by clicking on that field.
• Click on the parameter you wish to link to the selected Focus Field.
• To get an unassigned (empty) Focus Field, click again on the selected parameter.
• Once you have finished the assignments, click again on the Assign button to
leave the assign mode.
OVERLOAD INDICATION (O/L)
The two LEDs in the metering section, between the input and output meters, will light
up in case internal DSP overloads are detected. You should lower the input level to
avoid these overloads. To reset the indication, click on the O/L LED.