TC Electronic TC STEREO CHORUS/FLANGER User Manual

Summary of TC STEREO CHORUS/FLANGER

  • Page 1

    Tc stereo chorus/flanger & pitch modulator scf user’s guide.

  • Page 2: Contents

    3 contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 scf sound quality . . . . . . . . . . . . . . . . . . . . . . . . . . 7 front description . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3: Introduction

    4 thank you for purchasing the tc chorus/flanger/pitch modulation pedal. Tc electronic has developed this product to the highest standards ensuring top sound quality with no noise or distortion added to your audio signal. The "full" spatial effects and the lack of noise has made the tc scf pedal a f...

  • Page 4: Introduction

    6 pitch modulation: a combination of chorus and pitch - vibrato which creates a "light" chorus sound. Real stereo when using stereo the effect signals and the clean signal appear simultaneously in both sides. The effect signals are alternating phase reversed in left and right sides, creating a uniqu...

  • Page 5: Scf Sound Quality

    8 professional signal levels one of the key elements to obtaining professional sound quality is proper impedance at the in and output(s). If an effect pedal should be able to pick up the full bandwidth from your instrument, it is very important that it does not "load" your instrument, i.E. It must h...

  • Page 6: Front Description

    11 4 width determines how wide a modulation (sweep) is produced. Ranges are from "0" (no modulation) to "6"(max) on a relative scale. 5 input gain controls the gain of the built-in preamplifier. Ranges from 0db (no amplification) to +15db (= 5 times amplification). 6 overload indicates when the tc s...

  • Page 7: Front Description

    12 9 output outputs the right channel (stereo) of the stereo effects signal. 10 bypass switches the audio signal into or around the effects circuitry. 11 ex. Bypass by connecting a simple momentary switch here, the bypass function can be remote controlled. 12 led indicator the led at the top of the ...

  • Page 8: The Controls

    14 there are four sound controls on the scf: input gain, speed, width and intensity setting input gain: using the tc scf with an instrument… when used with a guitar, bass or keyboard with normal output volume and an amplifier with normal input volume the input gain should be turned fully counter clo...

  • Page 9: The Controls

    16 if you want "out of pitch" sounds for special effects, both speed and width can be turned into the last third of their range. Adjusting intensity this has 3 different functions depending on the mode setting… in the chorus mode intensity is a control for the "notching" depth of the chorus effect. ...

  • Page 10: Technical Specifications

    19 dynamic range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .100db frequency response . . . . . . . . . . . . . . . . . . . . . . . . . .20-20khz input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 mohm output impedance . . . . . . . . . . . . . . . . . . ...

  • Page 11: Troubleshooting

    21 error check distortion input gain adjusted too high - 0db max should be put in - install an input attenuator if necessary - try another signal source - try another cable - does the overload led light? Chorus effect do not mix the two outputs together disappears these are in anti-phase. To make a ...

  • Page 12: Troubleshooting

    22 intensity at or near maximum. This set-up will produce a chorus effect, which is almost as "broad" and is mono-compatible however the chorus effect will be at one side only. 3) use another tc product called the tc 1210 spatial expander & stereo chorus/flanger, which has two linkable chorus units ...

  • Page 13: Notes

    This equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate...

  • Page 14: Notes

    27 26 do not attempt servicing of this unit yourself. Always refer to qualified personal. Do not use this unit near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in wet basement or near a swimming pool ect. This unit should only be connected to correct power supply outlet...