TCL IP phone User Manual

Manual is about: VoIP terminal

Summary of IP phone

  • Page 1

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 1 chapter 1 product introduction 1.1 summary of the phone this unit is the latest generation voip terminal product applied to the ip network for voice communication. The heaviest characteristic of ip phone is that what transports voice over net...

  • Page 2: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 2 supports quick dial and redial functions resetting function when the phone meets catastrophic problems supports keypad 、 consoles port 、 telnet and web management modes 1.3 standard and protocol ieee 802.3/802.3 u 10 base-t/100base-tx support...

  • Page 3: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual 1.4 panel layout panel planform and rear panel figure 1.1 tcl-ip8 charts 1.5 key definition the function keys of the unit defined as below table1.1 key name definition flash press it to get the ip of the phone under standby status; flashing function shared with common phones ;...

  • Page 4: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 4 respectively. Ring in off state , press this key to browse and select your personal rings. Redial in picking state, redial the number menu in off state, press this key to enter the setting-up menu set in setting state, press this key to 1.Ent...

  • Page 5: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 5 number keys pick up the receiver or press the hand free key, and then press the number keys to dial (each key corresponds with 123456789*0#) in setting state, it is used to input ip address, port or password (each key corresponds with 1234567...

  • Page 6: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 6 chapter 2 phone setting the gift box of this unit packs the following parts: ip8 telephone set, adapter, connecting line, and the user’s manual etc. The fixing procedure: connecting this unit to network and the phone ports with the net-connec...

  • Page 7: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual figure 2.1 http login interface b 、 key in user name and password as “admin” and “123456” to enter the setting interface (for normal user is “user”and “1234”), the following interface will display after entering successfully, then select the items on the left side to set the p...

  • Page 8: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual figure 2.2 http login interface note: all the settings go into effect after restarting the phone. 2.1.1 network setting figure 2.3 shows the network setting and the protocol setting pages respectively. You can set the ip address, the subnet ip, the gateway ip and the correlati...

  • Page 9: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 9 figure 2.3 network setting interface.

  • Page 10: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual 2.1.2 protocol setting the phone supports sip protocol after finishing the network setting, enter “ protocol” interface (figure2.4) , all the parameters filled in the below form are provided by the isp.Upon the completion of the network setting and the protocol setting, you ne...

  • Page 11: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 11 figure 2.5 pppoe configurations figure 2.6 nat setting.

  • Page 12: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual 2.1.4 voice setting setting the agc 、 aec 、 codec and dtmf transmit mode in this menu , thereinto, vad 、 agc 、 aec will be available after giving each them a tip which factory default is not available ; and the default value of codec is “ auto ”, at that time ,the phone will a...

  • Page 13: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 13 figure 2.8 time zone setting 2.1.6 information view 2.1.6.1 version information the type of the protocol 、 software version and the release time information of the phone can be viewed in edition menu which is under “ info display ” column. D...

  • Page 14: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual 2.1.6.3 register information the register information of the phone can be viewed in the info display column. Figure 2.11 register information 2.1.6.4 communication record all the answered calls, missed calls, dialed numbers can be reviewed in the info display column. Figure 2....

  • Page 15: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual 2.1.7 system tools 2.1.7.1 default setting click the “factory default” to enter the factory default interface, click “ restore ” button to resume to factory default setting value.See as figure 2.14 figure 2.14 restore to factory default setting interface 2.1.7.2 software upgra...

  • Page 16: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual information and restarting the phone 2.1.7.3 revise the administer password the phone supports two grades user to sign in the interface, using “ admin” is as the administrator status, under which the user can reset all parameters in the interface, containing revises the passwo...

  • Page 17: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual figure 2.16 copy configuration interface 2)then click the backup setting button the save the info ( use .Conf as postfix ) 2.1.7.5 update the configuration file update the configuration file for the phone by using this item function. 1)click “ restore setting ” menu , the foll...

  • Page 18: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 18 “ missed calls ” and “ accepted calls ” one by one; press the “ set ” key prior to pressing ‘page up’ 、 ‘page down’ keys to play the “phone log” information, and user can dial out the phone number in the phone log directly by pressing the sh...

  • Page 19: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 19 b 、 setting the static ip address enter the “ network ” item in the same way, press the “ set ” key while the lcd displays “ local ip ” , and the phone will enter the changing mode of the parameters. Press “set” key to make sure the ip addre...

  • Page 20: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 20 appendix : trouble shooting guide 1.How to upgrade the software of tcl-ip8? Answer : enter web page of the phone, click the local upgrade menu , then get to the program files you want through the browse button, click “ upgrade ” . For detail...

  • Page 21: Tcl-Ip (8) User Manual

    Tcl-ip (8) user manual tcl communication www.Tclcomm.Cn 21 6.What kinds of voice codec can be selected for tcl-ip8? Answer : the default voice codec of tcl-ip8 is pcmu(g.711u).Pcmu and pcma both can supply better quality voice , but possess a big bandwidth which is up to 64kbps.If the network bandwi...