TCS Basys Controls SZ1063 Product Manual - page 3
2800 LAURA LANE • MIDDLETON, WI 53562 • (800) 288-9383 • FAX (608) 836-9044 • www.tcsbasys.com
3
Setup
note:
If using remote sensor(s), the calibration may need to be
adjusted. See “Checkout and Troubleshooting” section.
temPeRAtURe SenSoR SeleCtion
The dipswitches in the cover (shown above) must be set when using
remote room, and/or pipe temp sensors.
Use the following guide to determine the dipswitch settings for
your application.
Using built-in room sensor only. (this
is the default setting.)
Using built-in room sensor with pipe
sensor only. (SZ1064 only)
Using remote room sensor only.
Using remote room sensor with pipe
sensor only. (SZ1064 only)
Once the dipswitches have been set and
you have confirmed that the sensors are
reading correctly, secure the cover to the
base with the two set screws located at
the top right and the left side to prevent
tampering.
Programming
The SZ1063 and SZ1064 may be programmed through the keypad
on the face, or with a PC.
If programming with a PC, the following must be set through the face
prior to programming:
• Address (step #18)
• Baud rate (step #19)
• Temperature scale (step #20)
For more information on programming through the PC, consult your
TCS software manual.
PRogRAmming thRoUgh the keyPAd
To access the programming screens, press the program setup button.
Screens A thru F are monitoring screens and programming screens
begin with #1. Access may be locked out with dipswitches, or an
access code may be required.
program
setup
program
setup
BRANCH TO CLOCK/
10.
SCH. MENU?
YES
ENTER ACCESS
000
CODE
9.
NO
OVERRIDE ON
178 MINUTES
F.
program
setup
MOD OUT 1 00%
MOD OUT 2 00%
E.
program
setup
program
setup
PIPE TEMP:
D.
150F
DI3 OPEN
OFF
AUX RELAY
C.
program
setup
program
setup
DI2 OPEN
DI1 OPEN
B.
program
setup
A.
WED FAN:MED
3:27 PM
82F
1 2 3 4 5
main monitoring Screen
. Press the
program setup button to access the follow-
ing screens. (Day and date not shown on
SZ1063)
digital input 1 & 2 Status Screen.
Shows
the status of DI1& DI2.
digital input 3 Status & Auxiliary Relay
output Screen.
Shows the status of DI3.
Shows the status of the auxiliary relay out-
put. This can be either a timeclock output,
a stage of heat or a stage of cool. (Aux.
output on SZ1064 only)
Pipe temperature Screen.
Shows the pipe
temperature if a pipe temperature sensor
is used. (SZ1064 only)
modulating output 1 & 2 Status Screen.
Shows the percentage of modulating output
1 (heat) & output 2 (cool).
override Status Screen.
Shows the status
of the first and second stages of heating.
high
Occupied
Heating
Cooling
Data / Program
S ervice
C OOL E R
WAR ME R
Fan
fan
medium
fan
low
fan
fan
off
program
s etup
OVE R R IDE