TDK 2 Speaker Boombox User Manual - Installation
AC CONNECTION
Insert the small end of the AC adapter into the jack on the rear of
the unit. Insert the other end (with the 2 blades) into a
conveniently located AC outlet having 120V AC, 60Hz.
AC ADAPTER SPECIFICATIONS: DC 18V Z
NOTES:
• To disconnect the AC adapter, remove it from the DC IN jack
on the side of the unit as well as from the AC outlet.
• Use the enclosed AC adapter for this product only.
INSERTING BATTERIES
To use this unit with battery power,
remove the Battery Compartment
cover on the rear of the unit by
removing the three screws with a
flathead screwdriver, and then
lifting the cover off. Insert ten (10)
“D” cell batteries (not included),
observing the battery polarity
indicated inside the compartment. Replace the Battery Compartment cover and screws.
NOTE: The AC adapter must be disconnected from the jack on the rear of the unit in order for
the unit to operate on battery power. We recommend Alkaline or rechargeable types for
maximum cycle time and ecological efficiency.
STRAP
For ease of carrying, simply slide each strap end into the
strap holder on each side of this unit until it clicks in place,
as shown. Then, press the male buckle to release the strap.
6
INSTALLATION
AC Outlet
AC Adapter’s Plug
To DC 18V In Jack
+
–
+
–
+
– +
–
+
–
+
–
+
–
+
–
+
–
+
–
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.
Caution – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
2.
Use only the size and type of batteries specified.
3.
Be sure to follow the correct polarity when installing the batteries as indicated in the Battery
Compartment. A reversed battery may cause damage to the device.
4.
Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old
batteries with fresh ones.
5.
If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
6.
Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery
manufacturer’s directions.)
7.
Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.
PRESS THIS BUTTON