TDK 3 Speaker Boombox User Manual - Power Sources
AC CONNECTION
Insert the end of the power cord into the adapter, and then insert the small end of the AC
adapter into the DC IN jack on the rear of the unit. Insert the other end (with the 2 blades) into
a conveniently located AC outlet having 120V, 60Hz.
AC ADAPTER SPECIFICATIONS: DC 24V Z
NOTES:
•
To disconnect the AC
adapter, remove it from
the DC IN jack of the
unit as well as from the
AC outlet.
•
Use the enclosed AC adapter for this product only.
INSERTING BATTERIES
To use this unit with battery power, remove the Battery Compartment cover on the rear of the
unit by removing the three screws with a flathead screwdriver, and then lifting the cover off.
Insert twelve (12) “D” cell batteries (not included), observing the battery polarity indicated inside
the compartment. Replace the Battery Compartment cover and screws.
NOTE: The AC adapter must be disconnected from the jack on the rear of the unit in order for
the unit to operate on battery power. We recommend Alkaline or rechargeable types for
maximum cycle time or ecological efficiency.
6
POWER SOURCES
AC Plug
AC Outlet
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
+
–
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.
Caution – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
2.
Use only the size and type of batteries specified.
3.
Be sure to follow the correct polarity when installing the batteries as indicated in the Battery
Compartment. A reversed battery may cause damage to the device.
4.
Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old
batteries with fresh ones.
5.
If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
6.
Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery
manufacturer’s directions.)
7.
Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.