TDK TREK 360 Battery Replacement Manual

Page of 3

Download

Bookmark us

TREK 360 Battery Replacement Instructions

Caution: Disconnect the TREK 360 power and place the power switch on the rear

of the unit in the OFF position before beginning the replacement.

1. Place the unit on its left side. Using a

T-5 Torx driver, remove the four screws

holding the battery cover plate.

2. Place the unit upright. With a

jeweler’s screwdriver or a tweezers,

carefully pry out the battery cover

plate.

3. The battery compartment.

Page 1
Trek 360 battery replacement instructions caution: disconnect the trek 360 power and place the power switch on the rear of the unit in the off position before beginning the replacement. 1. Place the unit on its left side. Using a t-5 torx driver, remove the four screws holding the battery cover plat...
Page 2
4. Using a screw driver, lift on the lower corner of the battery assembly and rotate upwards. The battery will not lift straight up. 5. Lift the battery out. 6. Using fingers or a needle nosed pliers, unplug the connector..
Page 3
7. Remove the old battery and insert the replacement. 8. Plug in the connector, press the cable in place and replace the battery cover. 9. Reinstall the four retaining screws. Proper disposal of the old battery is essential from an environmental and safety point of view. Please follow local regulati...