Teac DA-88 Quick Reference - page 8
DA-88 quick ref.doc
10/14/97
7:27 PM
Page 8
© TEAC America, Inc., 1997 All rights reserved.
DA-88 Digital Dubbing
Requirements:
1 PW-88S Sync Cable
1 PW-88D Digital Dubbing Cable
1 RCA to RCA audio cable. (If dubbing Time code)
2 DA-88s (Both must have SY-88 Sync cards if dubbing Time code)
1 Pre-Formatted tape.
Procedure:
1) With power off, connect Source DA-88 SYNC OUT to Target DA-88 SYNC IN using the PW-88 Sync cable.
2) With Power off, connect Source DA-88 DIGITAL I/O port to Target DIGITAL I/O port using the PW-88D Digital
Dubbing cable.
If dubbing Time code, connect TC Out from source DA-88 to TC In on the target DA-88 using the RCA to RCA
audio cable.
3) Power On both DA-88s
4) On the Source DA-88, enter a 43 Fs Track Delay value for all 8 tracks.
a) Press DISPLAY until ABS is selected.
b) Hold the
and press DIGITAL IN. The display will toggle between Analog and Digital. Select DIGITAL.
c)If dubbing Time code, on Source DA-88 set menu Item 6 to Digital (old S1 #5 Up).
5) Load Master tape into Source DA-88 and the pre-formatted tape into the target DA-88.
NOTE: Make certain that the master tape is WRITE PROTECTED.
6) Make certain that the REC FUNCTION switches on the Source DA-88 are NOT ENGAGED.
7) Engage REC FUNCTION switches on the Target DA-88 to arm all tracks.
If dubbing Time code, engage the TC REC FUNCTION switch, but DO NOT start the generator.
8) Rewind both tapes to BOT
9) On the Target DA-88, engage DIGITAL IN, and CHASE.
10) On the Source DA-88, hold RECORD and press play.