Teac Ghetto Blaster PBT1000 User Manual - page 9
BASIC OPERATION
Sound and Volume Control
- Adjusti
-
ng volume can be done by rotating the
VOLUME knob on this unit or the device you
have already paired with.
NOTE: If there is no playback, ensure that the volume on both devices is not set to 0/Mute.
MP3 Playback via USB Thumb Drive or SD Memory Card
- To enter USB/SD Mode, press the
FUNCTION key until “USB” or “SD” is on the display.
- The following chart shows how to use USB/SD mode:
KEY
For USB thumb drive & SD Card
DISPLAY MODE
Switch between Spectrum Analyzer USB » Information » ID3 display
FOLDER+/ FOLDER -
Choose folder location on your USB/ SD Card (Not usable in
RANDOM play mode)
NEXT
Skip to the next song (Not usable in REPEAT 1 mode)
BACK
Skip to the previous song (Not usable in REPEAT 1 mode)
PLAY/ PAUSE
Start or pause music playback
P-MODE
Press repeatedly to switch between NORMAL PLAY » REPEAT 1 »
REPEAT ALL » REPEAT FOLDER » RANDOM PLAY
(NOTE: RANDOM PLAY is limited to songs within a selected folder
only.)
STOP
Press once: Stop playback (can be resumed from the same point)
Press twice: Reset playback memory (cancel resume)
NOTE: It takes time to read a large USB drive/SD card and count all the song files.
CAUTION - IMPORTANT: REMOVAL OF USB DRIVES & SD CARDS
Never remove SD cards or USB drives from the unit during playback. Always STOP playback,
then press the
FUNCTION key to switch to another mode (RADIO/BT) before removing your
USB/SD memory device to prevent damage to your song files and memory devices itself.
Audio Line In (Aux Input)
This unit comes with 2 Aux Input sockets (AUX IN 1/AUX IN 2), allowing you to connect two
external devices at the same time. You can switch between the 2 Aux Input sources to “mix”
your music quickly.
- Connect your external player to this unit using a standard stereo (3.5mm to 3.5mm) cable.
- Press the
FUNCTION key repeatedly until the display shows “AUX-1”/“AUX-2”, depending on
which socket you have plugged into. Ensure your AUX-1/AUX-2 socket device corresponds
to the correct display.
- Start audio playback on the connected external player.
- Adjust the volume control of the main unit and your external device to the desired level.
NOTE: Playback control can be done only through your external device. Remember to switch
off the unit when you finish using the external device.
To enhance the quality of music, this powerful sound system comes with two additional
equalization functions. At anytime during playback, you can rotate the bass and treble knobs
for stronger bass/ highs.
6