Teac MC-D67 Owner's Manual

Summary of MC-D67

  • Page 1

    Class 1 laser product this “bolt of lightning” indicates uninsulated material within your unit which may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. The “exclamation point” calls attention to features for which you should read the e...

  • Page 2

    Warranty registration please read this warranty card. Keep your purchase receipt to enable you to proceed quickly in the event of a warranty service. Warranty terms & conditions 1. Teac warrants to the original retail purchaser only, that this product is free from defects in material and workmanship...

  • Page 3

    Warranty procedures please keep this information for your own records. Please refer to the owner’s manual to ensure that you have followed the correct installation and operating procedures. 1. Read owner’s manual carefully 2. If you require warranty service, please contact the teac service centre 3....

  • Page 4

    En- 4 en- 5 features and controls main unit (see 1 ) power supply using ac power 1 check if the power voltage, as shown on the type plate located on the back of the set, corresponds to your local ac power supply. If it does not, consult your dealer or service centre. 2 connect the power cord to the ...

  • Page 5

    Recording general information on recording •recording is permissible in so far as copyright or other rights of third parties are not infringed. •this deck is not suitable for recording on chrome (iec ii) or metal (iec iv) type cassettes. For recording, use normal type cassettes (iec i) on which the ...

  • Page 6

    Precautions & general maintenance •place the set on a hard and flat surface so that the system does not tilt. •do not expose the set, batteries or cds to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. •do not cover the set. Adequate ventilation with a minimum ...

  • Page 7

    –problem •solution no sound /power –volume not adjusted •adjust the volume –power cord not securely connected •connect the ac power cord properly – • display does not function properly / no reaction to operation of any of the controls –electrostatic discharge •switch off and unplug the set. Reconnec...

  • Page 8

    National customer service centre (ncsc) free call: 1800 656 700 between monday to friday – est 9am to 5pm teac corporation 3-7-3, nakacho, musashino-shi, tokyo 180-8550, japan phone: (0422) 52-5081 teac australia pty.,ltd. A.B.N.: 11 113 998 048 head office 30 tullamarine park road, tullamarine, vic...