Teac PC-D880 Owner's manual - Controls
Main Unit
1.
PHONE JACK
- 3.5mm phone jack
2.
FUNCTION SELECTOR
- select the function CD/USB/AUX, FM or AM.
3.
VOLUME
- adjust volume level
4. MODE/PROGRAM
CD mode (during playing CD):
REPEAT, REPEAT ALL, RANDOM function
MP3 mode (during playing CD):
REPEAT, REPEAT ALBUM, REPEAT ALL,RANDOM function
Program memory (during stop CD):
Store up to 32 tracks in the desired sequence
5.
SEARCH
CD: - skip or search a passage / track backwards or forward
6.
FOLDER/+10
- MP3 folder up +10 each time
7.
DISPLAY
- show the CD/USB functions
8. FM ANT.
STOP
- stop CD/MP3 playback
9.
PLAY/PAUSE CD USB
-
- connect auxiliary device.
start or pause CD/USB play or switch CD or USB mode.
10. AUX IN
11.
CD DOOR
- open or close the CD door
12.
HANDLE
- carrying the device
13.
TUNING CONTROL
14.
USB INTERFACE
15.
16. AC main
- select FM/AM stations
- USB port.
- FM telescopic antenna.
- inlet for power cord.
Not Indicated:
Battery compartment (bottom panel)
4
Power Supply
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
. Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
. When inserting new batteries, do not try to mix old
batteries with new ones.
. Remove the batteries if the set is not to be used
for a long time.
Using AC Power
1 . Check if the power voltage, as shown on the type
plate located on the bottom of the set, corresponds
to your local AC power supply. If it does not,
consult your dealer or service centre.
2 . Connect the power cord to the AC mains inlet and
the wall outlet. The power supply is now
connected and ready for use.
3 . To switch off completely, unplug the power cord
from the wall outlet.
• Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
Whenever convenient, use the power supply if you want
to conserve battery life. Make sure you remove the plug
from the set and wall outlet before inserting batteries.
Batteries (not included)
Open the battery compartment and insert eight
batteries, type LR14,UM-2 or C cells, (preferably
alkaline ) with the correct polarity as indicated by the
“+”and “-”. symbols inside the compartment.
CONTROLS
POWER SUPPLY
Batteries contain chemical substances, so they
should be disposed of properly.