Teac PD-501HR Owner's Manual - Before Use
6
V
Placement precautions
o
Do not put anything on top of the unit.
o
Avoid placing the unit in direct sunlight or close to any
source of heat, such as a radiator, heater, open fireplace
or amplifier. Also avoid locations that are subject to vibra-
tions or exposed to excessive dust, cold or moisture.
o
This unit can be stacked with other 501 series models,
including the AI-501DA.
o
Place the unit in a stable location near the audio sys-
tem that you will use with it.
o
Do not move the unit during use.
o
The voltage supplied to the unit should match the volt-
age printed on the rear panel. If you are in any doubt
regarding this matter, consult an electrician.
o
As the unit could become warm during operation,
always leave sufficient space around it for ventilation.
When placing this unit, position it so that it is at least 3
cm (1.2") from walls in order to allow good heat dissipa-
tion. When installing it in a rack, leave at least 10 cm (4")
open behind the unit.
o
Do not open the body of the unit as this might result
in damage to the circuitry or cause electric shock. If a
foreign object should get into the unit, contact your
dealer or TEAC customer support.
o
When removing the power plug from the wall outlet,
always pull directly on the plug; never yank on the cord.
o
Depending on the electromagnetic waves of television
broadcasts, interference might appear on television
screens when this unit’s power is on. This does not
mean that this unit or the TV is malfunctioning. If this
occurs, turn this unit’s power off.
V
Use precaution
Listening to anything at a high volume for a long time
could be harmful to your hearing. In order to protect your
ears, be careful not to set the volume too high when lis-
tening with headphones for a long time.
Before use
Maintenance
If the surface of the unit becomes dirty, wipe it with a
soft dry cloth. If the unit becomes very dirty, dampen a
soft cloth slightly with a diluted neutral cleanser and thor-
oughly wring out any excess fluid before using the cloth
to wipe the unit.
Q For your safety, disconnect the power cord from
the socket before cleaning.
o
Never spray liquid directly on the unit.
o
Do not use thinner or alcohol as they could damage
the surface of the unit.
o
Avoid allowing rubber or plastic materials to touch this
product for long periods of time, because they could
damage the cabinet.