Teac SB04T User Manual - page 6
3D
+
2
3
8
1
4
8 7
3
1
5
4
2
Right Side
Remote Control
Front side
CONTROL AND INPUT :
CONNECTING THE UNIT
AC POWER
Insert the AC power plug correctly into a power outlet. The Red LED will light up and the unit is now in
Standby mode.
LINE IN JACK
Please make sure that the power is off when connecting and disconnecting.
Use the provided AUDIO CORD, connect the 3.5mm plug into the line in socket of the unit (on the right
side of the unit). Connect the RED and WHITE plug into the line out socket of the audio source.
Note : Please note that this is not a magnetically shielded speaker, do not place near to a CRT TV, as this
may cause discolouration.
INSTALLATION OF THE REMOTE CONTORL
CHANGING THE REMOTE BATTERY
1. Slide the BATTERY COMPARTMENT DOOR out of the remote.
2. Install 1 x "CR2025" battery or an equivalent battery.
3. Slide the BATTERY COMPARTMENT DOOR back into the remote.
CAUTION : Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
USING THE REMOTE CONTROL
This remote control makes it easy to control the unit from a distance of up to 3m away. You need to point it
at the remote sensor on the front panel of the unit.
OPERATION
1. Press the ON / STANDBY Button and the GREEN LED will light up.
2. Turn on the power of the audio source (e.g. TV, DVD player) and play audio on the device.
3. Press the Volume Up Button to increase the volume output level.
4. Press the Volume Down Button to decrease the volume output level.
5. Press the 3D Button to turn on the 3D sound effect. Press once more to turn off the 3D sound effect.
6. Press the MUTE Button (on the remote control only) to mute the sound.
7. Press the ON / STANDBY Button and the LED will change to RED. The unit is now in Standby Mode.
1.
Volume Up Button
2.
Volume Down Button
3.
3D Button
4.
ON / Standby Button
5.
Line In Socket
6.
Mute Button (on remote control only)
7.
ON / Standby LED Indicator
8.
Remote Sensor
2
Teac SB04T (AUST).p65
2011/4/14, ¤W¤È 10:41
6