ThePondguy ClearVac Installation & Maintenance Manual - Using The
USING THE
CLEARVAC
™
VACUUM:
Position the Vacuum
Position the ClearVac™ near the ponds edge and plug into
a GFCI outlet. The ClearVac™ can be used with an extension
cord but it must be a 10 or 12 gauge outdoor rated
extension cord no longer than 50’.
Turn on the Vacuum
Turn the power switch to the “ON” position and submerge
the end of the suction hose in the pond.
Vacuum Debris
Move in a slow, uniform fashion to remove sludge, debris
and algae. When the reservoir becomes full, the ClearVac™
will automatically switch reservoirs and drain allowing for
continuous vacuuming.
Turn Off the Vacuum
When finished, turn the power switch to the “OFF” position
and unplug the ClearVac™. Be sure to clean the unit after
each use before storing.
Adjust the Suction
Using the vacuum level adjustment on the handle of
the suction hose, slowly close the valve to increase the
suction and lift unwanted debris.
WARNING:
Before performing any maintenance, always unplug the ClearVac™
from the power source.
• Clean the collection chamber, tubes and foam filters after
operating and rinse with clean water.
• Check o-rings and foam filters for wear or damage and replace
if needed.
WARNING:
For your protection, always unplug the ClearVac™ from your power source before servicing.
Little or no suction is produced:
• Be sure the ClearVac™ is positioned at or near water level.
• Remove and inspect the intake distributor, intake and suction hoses for obstructions.
• Reduce the number of extension tubes used
• Be sure the suction hose is lying as flat as possible with no kinks.
• Check to be sure that o-rings are installed properly.
Unit does not reach full capacity or collection chamber does not drain:
• Clean foam filters
• Remove and inspect the intake distributor, intake and suction hoses for obstructions.
• Check for kinks in discharge hose, lay discharge hose flat or at a slight decline to aid in draining.
• Check drain opening for blockages
Unit develops noise or heavy vibration:
Turn the power switch off for 20 seconds and then restart the unit. If issue persists try the following:
• Make sure collection chamber is not full and that it is draining properly
• Clean foam filters
• Remove and inspect the intake distributor, intake and suction hoses for obstructions.
Vapor escapes from the unit:
• In cold weather, condensation forms in the unit and it released as water vapor. This is normal and no
remedy is necessary.
• The ClearVac™ hoses and
extensions easily disassemble
and can be stored right on
the unit.
• The ClearVac™ includes a
handle for easy mobility.
Simply unthread the tension
knob, adjust the handle
and retighten.
• The ClearVac™ should be stored in a dry, temperature controlled room.
thepondguy.com | 866-POND-HELP (766-3435)
15425 Chets Way | Armada, MI 48005
6
7