Thermador 9000039271 Installation Instructions Manual

Manual is about: Thermador Dishwasher User Manual

Summary of 9000039271

  • Page 1

    1 important instructions important • the dishwasher drain hose must be installed with a portion of it at least 20” (508mm) off the cabinet floor; otherwise the dishwasher may not drain properly. • this dishwasher is intended for residential use only, and should not be used in commercial food service...

  • Page 2: Tools Needed

    2 tools needed hammer hole saw pipe wrench tape measure slot screwdriver phillips screwdriver torx screwdriver wire cutter wire stripper drill level adjustable wrench electrical supply cable- minimum #14 awg, 2 conductor, 1 ground, insu- lated copper conductors. Hot water supply line - minimum 3/8” ...

  • Page 3: Materials Supplied

    3 accessory parts supplied accessory parts for your dishwasher will come in one or more plastic bags. Check to make sure that the parts shown in figure 1 are included with your model. If any parts are missing, contact your dealer immediately. Note: illustrations are not to scale. Manual set bag this...

  • Page 4: Enclosure Preparation

    4 note: this dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry. Select a location as close to the sink as possible for easy access to water supply and drain lines. For proper dishwasher operation and appearance, ensure that the enclosure is squ...

  • Page 5: Electrical Preparation

    5 warning: electrical shock hazard - working on an energized circuit could result in serious injury or death. Only qualified electricians should perform electri- cal work. Do not attempt any work on the dishwasher electric supply circuit until you are certain the circuit is de-energized. Warning: fi...

  • Page 6: Plumbing Preparation

    6 warning: scald hazard - serious injury could result if work is performed on a charged hot water line. Only qualified plumbers should perform plumbing work. Do not attempt any work on the dishwasher hot water supply plumb- ing until you are certain the hot water supply is shut off. Caution: tempera...

  • Page 7: Dishwasher

    7 drain plumbing dishwasher connection piece if the dishwasher is to drain either directly into the household drain plumbing or through an air gap, install a dishwasher connection piece under the sink, as shown in figure 8, letter a. Installing an air gap if local ordinances require an air gap, as s...

  • Page 8

    8 removing the toe panel dwhd94bf regular toe panel the toe panel is loosely attached with tape. Remove the tape and pull the toe panel away from the dishwasher. Set the toe panel aside. It will be reinstalled later. Dwhd94bp and dwhd94bs base and toe panel the base and toe panel are in place on the...

  • Page 9: Door Panel Installation

    9 dwhd94bf - panel installation dwhd94bf models come with additional mounting hardware and a template sheet that will show you how to mount the panel. One side of the template shows how to mount a one piece panel; the other side shows how to mount a two piece panel. Decide which type of installation...

  • Page 10: Securing The

    10 1. Straighten and position the hot water supply line and the electrical supply cable as shown in figure 16 so that they will align with their channels under the dishwasher base. 2. Position the dishwasher close enough to the enclosure so that you can run the dishwasher drain hose to the under sin...

  • Page 11: Drain Hose Connection

    11 the dishwasher drain hose may be connected to the drain plumbing in one of four ways: 1. Directly to the undersink dishwasher drain connection, as shown in figure 20. 2. Directly to a disposer dishwasher drain connec- tion, as shown in figure 21. 3. To the undersink dishwasher drain connection th...

  • Page 12: Hot Water Connection

    12 warning: scald hazard - working on a charged hot water line could result in serious injury or death. Do not attempt any work on the dishwasher hot water supply plumbing until you are certain the hot water supply is shut off. Note: make certain that the correct 90° elbow fitting (not supplied) for...

  • Page 13: Electrical Connection

    13 warning: electrical shock hazard - working on an energized circuit could result in serious injury or death. Only qualified electricians should perform electrical work. Do not attempt any work on the dishwasher electric supply circuit until you are certain the circuit is de-energized. Warning: fir...

  • Page 14: Base And Toe Panel

    14 warning: fire hazard - loose or improper electrical connections can cause fire. Make certain that all electrical connections are properly made. • do not pre-twist the wires before connecting them with wire nuts. • extend the dishwasher’s stranded wires 1/8” (3mm) beyond the power supply cable’s s...

  • Page 15: Final Instructions

    15 dwhd94bp and dwhd94bs base and toe panel installation 1. Place the base part under and up the front bottom panel of the dishwasher, as shown in figure 29. 2. Insert the base part screws (figure 1, letter o) into the base part, as shown in figure 29, letter b. Tighten the base part screws. 3. Plac...

  • Page 16: Customer Service

    16 please be sure to include (if you are writing), or have available (if you are calling), the following information: • model number • serial number • date of original purchase • date the problem originated • explanation of the problem also, if you are writing, please include a daytime phone number ...