Thermador UCV30 Installation Instructions Manual - Safety Instructions

SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

A.

Installation work and electrical wiring must be

done by qualified person(s) in accordance with

all applicable codes and standards, including

fire-related construction.

B .

Sufficient air is needed for proper combustion

and exhausting of gases through the flue

(chimney) of fuel burning equipment to prevent

backdrafting.  Follow the heating equipment

manufacturer's guideline and safety standards

such as those published by the National Fire

Protection Association (NFPA), and the Ameri-

can Society for Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local

code authorities.

C

When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utili-

ties.

D.

Ducted fans must always be vented to the

outdoors.

E .

Always unplug or disconnect the downdraft

from the power supply before servicing.

TABLE OF CONTENTS

Safety Instructions .............................................................................................................................................. pg.  1

Introduction .......................................................................................................................................................... pg.  2

Step 1

Plan the Installation ......................................................................................................................... pg.  3

Step 2

Prepare Countertop Cutout ........................................................................................................... pg. 7

A . Installation with Thermador Cooktop ................................................................................ pg. 8

B . Installation with Another Brand of Cooktop ................................................................... pg. 9

Step 3

Prepare Duct Cutouts in Cabinet ............................................................................................... pg. 10

Step 4

Install Ductwork (Remote Blower- if used) .......................................................................... pg. 11

Step 5

Install Electrical Service ................................................................................................................ pg. 11

Step 6

Mount Vent and Cooktop .............................................................................................................. pg. 11

Step 7

Mount Integral Blower or Remote Blower ............................................................................. pg. 12

Step 8

Verify Installation Operation and Cooktop Alignment ..................................................... pg. 13

Page 1

WARNING

THIS PRODUCT IS INTENDED FOR

GENERAL VENTILATING USE ONLY.  DO

NOT USE TO EXHAUST HAZARDOUS OR

EXPLOSIVE MATERIALS OR VAPORS.

WARNING

TO REDUCE RISK OF FIRE AND TO PROP-

ERLY EXHAUST AIR, BE SURE TO DUCT

AIR OUTSIDE. DO NOT VENT EXHAUST

AIR INTO SPACES WITHIN WALLS, CEIL-

INGS, ATTICS,  CRAWL SPACES OR GA-

RAGES.

WARNING

TO REDUCE THE RISK OF FIRE, USE

ONLY METAL DUCT WORK.

WARNING

TO REDUCE THE RISK OF FIRE, ELEC-

TRIC SHOCK AND INJURY TO PERSONS,

VENTILATOR ASSEMBLIES, MODELS

UCV30, UCV36 AND UCV45 MUST BE

INSTALLED WITH INTEGRAL BLOWER,

MODEL VTN600CVA OR REMOTE BLOW-

ERS MODEL VTR600R OR VTR1000Q.

OTHER VENTILATOR BLOWERS CANNOT

BE SUBSTITUTED.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK, OR INJURY TO PERSONS,

OBSERVE THE FOLLOWING: