Trionic Veloped 12er L User Manual - User Manual

Summary of Veloped 12er L

  • Page 1

    User manual english.

  • Page 2: User Manual

    User manual dear user, thank you for choosing our product! We truly hope you will experience many pleasant moments and enjoy your trionic veloped both off-road and in the city. By choosing a trionic veloped you will enjoy a whole range of benefits, and it will improve your access to different outdoo...

  • Page 3

    Trionic veloped the veloped has a unique 3-wheel design, but as you can see it has in fact four wheels. It’s aimed to be used as a walking aid, especially for people with the desire to be physically active out- doors. Developed with a focus on walking and facilitating access for the user, the velope...

  • Page 4: The Product

    The product technical data 12er m 12er l 14er m 14er l min. Height: 75 cm 82 cm 77 cm 84 cm max. Height: 95 cm 102 cm 97 cm 104 cm width: 76 cm 79 cm 76 cm 79 cm length: 102 cm 102 cm 107 cm 107 cm seat height: 58 cm 63 cm 60 cm 65 cm seat width: 44 cm 44 cm 44 cm 44 cm wheel size: 12”/31 cm 12”/31 ...

  • Page 5

    Safety • both brakes should be locked in par- king mode before you use the seat. • before you start walking with the velo- ped, make sure it’s completely unfolded. • be extra careful in steep terrain and on slanting ground. • the stability of the veloped is tested with a basket load of 5 kg. If you ...

  • Page 6

    1. Attach the rear wheels to the frame’s rear axle holes by press- ing the black button in the cen- tre of the wheel and then push- ing the axle all the way into the axle hole. Release the push button. 2. Check that the wheels are properly attached by pulling/ pushing them sideways. 3. Attach the fr...

  • Page 7

    1. Unfold the veloped by pull- ing the gripbar handles side- ways, away from each other. Walking mode 2. Check that the veloped locks in walking mode; when unfolding it make sure you hear a click from the telescopic stay locking into position. 3. The seat can be slid forward and rearward. Push it fo...

  • Page 8

    Folding the veloped 1. Pull the seat to the rear. 2. Press the button on the right of the telescopic stay. 3. Simultaneously lift and fold one frame half against the other. 4. Press the other button on the left of the telescopic stay. 5. Simultaneously lift and fold one frame half against the other ...

  • Page 9

    To operate the motion brake, pull the brake lever upwards. Brake with both levers at the same time. You can engage the parking brake in 3 different ways. Option 1: push the lower red parking trigger downwards with your index finger, while you pull the brake lever at the same time. Make sure that the...

  • Page 10

    1. Release both quick-release levers by folding them out- wards. 2. Adjust the gripbar to required height, the most ade- quate being the distance from the wrist to the ground when standing with the arms hang- ing freely. Use help to measure! Note: the easiest way to adjust the gripbar is when sit- t...

  • Page 11

    The angle of the grips can be adjusted so that you get a com- fortable hand position and an optimal support. 1. Loosen the screw on the rear end of the grip with a 4 mm allen key. 2. Turn/rotate the grip to your chosen angle. 3. Tighten the screw on the rear end of the grip with a 4 mm allen key. Gr...

  • Page 12

    Installing the rear wheels the rear wheels are removable to simplify transportation of the veloped. 1. To remove the wheel, press the black button at the centre of the wheel and pull the wheel off. 2. To attach the wheel, press the black button at the cen- tre of the wheel and push the wheel axle in...

  • Page 13

    The front wheel suspension is removable to simplify trans- portation of the veloped. 1. Press the black button under the front hinge to release the front wheel suspension. 2. To remove the entire wheel suspension, lift the frames front end from the surface while pulling the wheel sus- pension downwa...

  • Page 14

    There is an adjustment handle on the front wheel, placed in the between the wheels, that can be shifted between two settings. Lower position: offers easy turning with retained climbing capacity. Upper position: offers increased climb- ing capacity, suspension on uneven surfaces and a higher directio...

  • Page 15

    The basket of the trionic veloped has a 22-litre load- ing capacity. It has a small zippered pocket at the rear end for valuables and smaller objects. The veloped basket is removable, and is attached to the frame basket rails with three velcro sections. 1. Wrap the rear velcro flaps around the rails...

  • Page 16

    The veloped’s sliding seat is comprised of a seat base and a removable cover fixed with nine push buttons. 1. Hold the seat cover with the text trionic to the right. Wrap the long flap between the teles- copic stay and the seat base. 2. Attach the three front push buttons of the long flap to the sea...

  • Page 17

    Safety instructions before use, check that your trionic veloped functions properly: • check the function of the motion and parking brakes. • make sure that the frame is locked in unfolded walking mode. • check that the gripbar is properly secured at the correct height. • avoid contact with the front...

  • Page 18

    Seminariegatan 29 c se-752 28 uppsala, sweden www.Trionic.Se, info@trionic.Se tel.: +46 8 522 100 50, fax.: 08-522 100 59 max sn: 201202-000138 art no: 11-00-011 max weight: 150 kg width: 76 cm length: 102 cm height: 75-94 cm 2010-02 primarily for outdoor use iso 11199.2:2005 s guarantee the trionic...

  • Page 19

    Troubleshooting if your trionic veloped does not work satisfactory, you can check it by following the troubleshooting guide below. If the guide does not help you solve the problem, please contact your retailer, service provider, distributor or trionic sverige ab. Environmentally friendly the trionic...

  • Page 20

    Trionic sverige ab seminariegatan 29 c se-752 28 uppsala sweden www.Trionic.Biz info@trionic.Se telephone: +46 8 522 100 50 fax: +46 8 522 100 59 corp.Id: 556698-1527. Vat reg. No se556698152701.