Tripp Lite APS 1024 INT Owner's Manual - page 2
1. OFF/ON Switch:
Move this switch to the "ON" position to have your Inverter provide connected
equipment with AC power by converting DC power from an attached battery. To prevent battery
drain, leave it in the "OFF" position when not using connected equipment.
2. BATTERY HI/MED/LOW LEDs:
These three lights show the approximate charge of your
connected batteries. See chart below for approximate charges.
LEDs Illuminated
Approximate Charge
Green
96% - Full
Green & yellow
81% - 95%
Yellow
61% - 80%
Yellow & red
41% - 60%
Red
21% - 40%
All three lights off
1% - 20%
Flashing red
0% (Inverter shutdown)
All three lights flash slowly
Excessive discharge
All three lights flash quickly
Overcharge or charger fault
3. LOAD LOW/MED/HI LEDs:
These three lights show the approximate voltage demand on your
Inverter. See chart below for approximate load levels.
LEDs Illuminated
Approximate Load
Green
0% - 20%
Green & yellow
21% - 40%
Yellow
41% - 60%
Yellow & red
61% - 80%
Red
81% - Full
All three lights off
Inverter off
Flashing red
Overload
4. RJ45 Remote Ports (bottom panel, not shown):
Use to connect the Remote Control Module
to either an Inverter or a second Remote Control Module. See Installation section, previous page.
5. Ignition Lockout Port:
Use to connect the Remote Control Module to your vehicle's ignition
(with cable supplied on select models only) in order to automatically switch off the Inverter when
the vehicle's ignition is turned off. See Installation section, previous page.
Operation
OFF
ON
LOAD
BATTERY
LOW
MED
HI
HI
MED
LOW
PV
INVERTER (PV series)
2
4
*
1
3
5
Choose operation based on whether you connect your Remote Control Module to an Inverter
(PV series) or Inverter/Charger (APS, RV or EMS series).
* Bottom panel, not shown
200208166 93-2079 APS-PV Remote II-DR Owner’s Manual.qxd 9/9/2002 4:07 PM Page 2