1. DL manuals
  2. Tripp Lite
  3. TV Mount
  4. DWT2647XP
  5. Owner's Manual

Tripp Lite DWT2647XP Owner's Manual

Summary of DWT2647XP

  • Page 1

    1 owner’s manual warr anty registr ation register online today for a chance to win a free t ripp lite product! Www .Tripplite.Com/warranty tilt flat screen wall mount model: dwt2647xp caution: do not exceed maximum listed weight capacity. Serious injury or property damage may occur! 1111 w. 35th str...

  • Page 2

    2 note: read the entire instruction manual before you start installation and assembly. Warranty & warranty registration warning • do not begin the installation until you have read and understood the instructions and warnings contained in this manual. If you have any question regarding any of the ins...

  • Page 3

    3 important: ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, visit www.Tripplite.Com/support for service. Component checklist (x1) (x1) (x1) m5x14 (x4) m8x30 (x4) anchor bolt (x6) concrete anchor (x6) d6 washer (x6...

  • Page 4

    4 1a. Mount on wood stud wall 1 2 3 find and mark the exact location of mounting holes screw the wall plate onto the wall drill pilot holes warning • make sure that mounting screws are anchored into the center of the studs. Use of a stud finder is highly recommended. • installers are responsible to ...

  • Page 5

    5 1b. Mount on solid brick and concrete block mark the exact location of mounting holes screw the wall plate onto the wall drill pilot holes warning • when installing wall mounts on cinder block, verify the actual concrete thickness is at least 1-3/8” (35mm) for using the concrete anchors. Do not dr...

  • Page 6

    6 note: choose appropriate screws, washers and spacers (if necessary) according to the type of screen. • position the adapter brackets as close as possible to the center of the display. • screw the adapter brackets onto the display. Tighten all screws but do not over tighten. 2. Install adapter brac...

  • Page 7

    7 3. Hang display onto the wall plate 4. Adjustment bolt wall wall tighten the two bolts by using an appropriate phillips screwdriver to secure bracket. Loosen the adjusting knobs to tilt to desired angle then retighten the knobs. Maintenance • check that the bracket is secure and safe to use at reg...

  • Page 8

    8 1111 w. 35th street, chicago, il 60609 usa • www.Tripplite.Com/support 13-09-232 • 93-32a2_reva 13-09-232-9332a2.Indd 8 11/8/2013 2:09:00 pm.