Tripp Lite DWT3285L Owner's Manual

Manual is about: Tilt Flat Screen Wall Mount

Summary of DWT3285L

  • Page 1

    1 owner’s manual tilt flat screen wall mount model: dwt3285l caution: do not exceed maximum listed weight capacity. Serious injury or property damage may occur! 1111 w. 35th street, chicago, il 60609 usa • www.Tripplite.Com/support copyright © 2014 tripp lite. All rights reserved. 200 x 200 to 700 x...

  • Page 2

    2 note: read the entire instruction manual before you start installation and assembly. Warranty & warranty registration warning • do not begin the installation until you have read and understood the instructions and warnings contained in this manual. If you have any questions regarding any of the in...

  • Page 3

    3 component checklist important: ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, visit www.Tripplite.Com/support for service. Wall bracket (1) mount arms (2) mesh sleeve (1) 4mm security hex key (1) m8x20 (4) m6x14...

  • Page 4

    4 1a. Mount on wood stud wall 1 2 3 find and mark the exact location of mounting holes screw the wall plate onto the wall drill pilot holes warning • make sure that mounting screws are anchored into the center of the studs. Use of an edge-to-edge stud finder is highly recommended. • never tighten in...

  • Page 5

    5 1b. Mount on solid brick, cinder block or concrete wall concrete anchor metal washer lag bolt mark the exact location of mounting holes screw the wall plate onto the wall drill pilot holes warning • when installing wall mounts on a concrete wall, the wall must be at least 8” thick with a minimum c...

  • Page 6

    6 note: choose appropriate screws, washers and spacers (if necessary) according to the type of screen. • position the adapter brackets as close as possible to the center of the display. • screw the adapter brackets onto the display. Tighten all screws but do not over tighten. 2. Attach mount arms to...

  • Page 7

    7 3. Attach mount arms to wall bracket maintenance • check that the bracket is secure and safe to use at regular intervals (at least every three months). • please visit www.Tripplite.Com/support if you have any questions. • attach display to wall bracket and slide into position. Loosely fasten mount...

  • Page 8

    8 4. Height and level adjustment adjust display as desired. • turn knob clockwise to raise side. • turn knob counter-clockwise to lower side. Up rotate left rotate right down 13-09-030-9332e8-en.Indd 8 4/3/2014 2:58:03 pm.

  • Page 9

    9 5. Tilt and depth adjustment adjust display as desired. • turn knob clockwise to move corner towards the wall. • turn knob counter-clockwise to move corner away from the wall. Note: adjustments are made with the wall bracket open (see step 8 for instructions on opening the unit) and you facing the...

  • Page 10

    10 6. Cable management 7. Opening and closing wall bracket display cables can be routed along top or bottom of wall bracket. • use mesh sleeve and cable ties for cable management. To open wall bracket, push or pull up on locking tabs. Important: open position is for service access only. The bracket ...

  • Page 11

    11 1 2 8. Opening and closing mount arms orange cord orange cord black cord black cord pull down pull down open mount arms by pulling down on the orange cords while an assistant pulls the bottom of the display up and away from the wall. Important: open position is for service access only. The bracke...

  • Page 12

    12 1111 w. 35th street, chicago, il 60609 usa • www.Tripplite.Com/support 13-09-030 • 93-32e8_reva 9. Securing wall bracket (optional) to prevent locking tabs from releasing, secure them with the two m5x10 security screws provided. M5x10 13-09-030-9332e8-en.Indd 12 4/3/2014 2:58:07 pm.