Tripp Lite Isobar Owner's Manual
1
Copyright © 1999 Tripp Lite. All rights reserved. Isobar
®
and Isotel
®
are registered trademarks of Tripp Lite.
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support: (773) 869-1234
www.tripplite.com
Owner's Manual
Isobar
®
, Isobar
®
Ultra,
Isotel
®
& Isotel
®
Ultra
Premium Surge Suppressors (120V)
ESPAÑOL : p. 5
FRANÇAIS : p. 9
Storage & Service:
p. 5
Specifications:
p. 6
Warranty & Insurance: p. 6
• Install your surge suppressor indoors, away from excess moisture, heat and dust.
• Connect your surge suppressor to a three-wire, grounded AC power outlet. Do not
remove or modify the ground pin of the surge suppressor's plug. Do not use two-
prong adapters with the surge suppressor's plug.
• Your surge suppressor does not require maintenance. Do not open your surge
suppressor for any reason. There are no user-serviceable parts inside.
Safety
Quick Installation
Basic Operation:
p. 4 - 5
Safety:
p. 2
Plug surge suppressor into a three-
wire, grounded 120V electrical outlet.
The surge suppressor cannot provide full protection unless it is
plugged into a properly wired and grounded outlet.
Flip surge suppressor’s ON – OFF
switch ON (switch will light up.)
When this switch is lit, it indicates that AC power is enabled at the
surge suppressor's outlets.
Plug the power cords of your
electrical equipment into your surge
suppressor's outlets.
Your electrical equipment is now protected from AC surges on the
power line. Note for models with more than 2 outlets: the outlets
are arranged into pairs called isolated filter banks. For best
results, plug heavy power draw devices such as printers into the
banks closest to the surge suppressor's power cord and sensitive
equipment such as computers into the banks furthest from the
surge suppressor's power cord. This gives sensitive equipment the
greatest protection from AC surges and isolates it from line noise
from heavy power draw devices.
2
1
3