Tripp Lite PDU10K Owner's Manual

Owner’s Manual

PDU10K Power Distribution Unit (PDU)

for select UPS Systems

Designed for 2U rack and other mounting options

Congratulations! Your power distribution unit will add a wide range of electrical outlets to select Tripp Lite

SmartOnline

TM

UPS Systems and SmartPro

®

UPS Systems. 

A variety of installation options are available: 2U

rackmount, wall mount, under-console mount and

more.

Note: The user must supply and determine the

fitness of all hardware (including rackmount

screws, bolts and cage nuts) required in the

installation process; the user must also determine

the fitness of the mounting surface.

On each side of the unit, run four rackmount

screws through star washers, through one of the

mounting clips and into the unit's pre-drilled holes.

The mounting clips can be oriented in a variety

of ways to suit a variety of applications. A recessed

rackmount installation allows space for connected

cables in front of the rack or enclosure.

B

A

Installation

A

IMPORTANT SAFETY INSTRUCTIONS. This manual contains information 

concerning the proper installation and use of Tripp Lite’s Power Distribution

Units (PDUs). SAVE THESE INSTRUCTIONS.

Note: This PDU is intended only for use with select Tripp Lite UPS Systems.

The PDU's input must be grounded. Do not use it with extension cords or adapters that

eliminate its connection to ground. Your PDU is designed for indoor use only. Install it

away from heat emitting devices such as radiators and heat registers. Do not install where

excessive moisture or other conductive contaminants are present. Never install electrical

wiring during a lightning storm.

B

Standard PDU Shown

(Outlet Configuration Varies Depending on Model)

200402057 PDU10K Owner’s Manual.qxd  2/12/2004  4:29 PM  Page 1