Tripp Lite PowerVerter APS Series Owner's Manual

Other manuals for PowerVerter APS Series: Owner's Manual, Owner's Manual, Owner's Manual
Manual is about: DC-to-AC Inverter/Chargers

Summary of PowerVerter APS Series

  • Page 1

    Owner’s manual quiet mobile power congratulations! You've purchased the most advanced, feature-rich inverter/charger designed as an alternative energy source for residential, commercial or recreational vehicle applications. Tripp lite inverter/chargers are the quiet alternative to gas generators—wit...

  • Page 2

    2 important safety instructions save these instructions! This manual contains important instructions and warnings that should be followed during the installation, operation and storage of this product. Location warnings • although your inverter/charger is moisture resistant, it is not waterproof. Fl...

  • Page 3: Feature Identification

    3 feature identification identify the premium features on your specific model and quickly locate instructions on how to maximize their use. Configuration dip switches: optimize inverter/charger operation depending on your application. See configuration section for setting instructions. Operating mod...

  • Page 4: Operation

    4 operation switch modes after configuring, mounting and connecting your inverter/charger, you are able to operate it by switching between the following operat- ing modes as appropriate to your situation: “auto/remote”: switch to this mode when you need constant, uninterrupted ac power for connected...

  • Page 5: Configuration

    5 configuration set configuration dip switches using a small tool, set the configuration dip switches (located on the front panel, see diagram) to optimize inverter/charger operation depending on your application. Refer to the appropriate section to review the instructions for your specific model. I...

  • Page 6: Configuration

    6 select battery charger-limiting points “most limiting” (b2 & b1 up): charger- limiting takes effect the moment any ac load is applied; charger output falls gradu- ally from full output at no ac load passing through to no output at full load (factory set- ting). "less limiting" (b2 up & b1 down): c...

  • Page 7: Battery Selection

    7 battery selection select auxiliary battery type (if any) select “deep cycle” batteries to receive optimum performance from your inverter/charger. Do not use ordinary car or starting batteries or batteries rated in cold cranking amps (cca). If the batteries you connect to the inverter/charger are n...

  • Page 8: Mounting

    8 mounting warning! Mount your inverter/charger before dc battery and ac power connection. Failure to follow these instructions may lead to personal injury and/ or damage to the inverter/charger and connected systems. Tripp lite manufactures a variety of different inverter/chargers with a variety of...

  • Page 9: Battery Connection

    9 • connect dc wiring: though your inverter/charger is a high-efficiency converter of electricity, its rated output capacity is limited by the length and gauge of the cabling running from the battery to the unit. Use the shortest length and largest diameter cabling (maximum 2/0 gauge) to fit your in...

  • Page 10: Ac Input/output Connection

    10 to avoid overloading your inverter/charger, match the power requirements of the equipment you plan to run at any one time (add their total watts) with the output wattage capacity of your inverter/charger model (see specifications). Do not confuse “continuous” wattage with “peak” wattage ratings. ...

  • Page 11: Troubleshooting

    11 troubleshooting try these remedies for common inverter/charger problems before calling for assistance. Call tripp lite customer service at (773) 869-1234 before returning your unit for service. Limited warranty tripp lite warrants its inverter/chargers to be free from defects in materials and wor...

  • Page 12

    1111 w. 35th street, chicago, il 60609 usa 773.869.1234 (usa) • 773.869.1212 (international) www.Tripplite.Com 200812163 93-2803_en.