Tripp Lite PowerVerter DC-to-AC Inverter/Charger APSX700HF Owner's Manual

Manual is about: DC-to-AC Inverter/Charger

Summary of PowerVerter DC-to-AC Inverter/Charger APSX700HF

  • Page 1

    Owner’s manual powerverter ® dc-to-ac inverter/charger model: apsx700hf input output invert: 12 v dc 230 v, 50 hz ac charge: 230 v, 50 hz ac 12 v dc 1111 w. 35th street, chicago, il 60609 usa +1 773 869 1234 • www.Tripplite.Com reliable emergency backup power congratulations on your purchase of the ...

  • Page 2

    2 important safety instructions save these instructions! This manual contains important instructions and warnings that should be followed during the installation, operation and storage of this product. Failure to comply will void the warranty. Location warnings • install your inverter/charger (wheth...

  • Page 3: Features

    3 features operating mode switch: controls inverter/ charger operation. When this switch is set to “auto”, connected equipment receives constant, uninterrupted utility ac power, with simultaneous charging of connected batteries. The “charge only” setting prevents unwanted battery rundown when there ...

  • Page 4: Battery Selection

    4 match battery amp-hour capacity to your application select a battery or system of batteries that will provide your inverter/charger with proper dc voltage and an adequate amp-hour capacity to power your application. Even though tripp lite inverter/chargers are highly efficient at dc-to-ac inversio...

  • Page 5: Mounting

    5 mounting warning! Mount your inverter/charger before dc battery and ac power connection. Failure to follow these instructions may lead to personal injury and/or damage to the inverter/charger and connected systems. Tripp lite recommends that you permanently mount your inverter/charger in the confi...

  • Page 6: Battery Connection

    6 battery connection • connect dc wiring: though your inverter/charger is a high-efficiency converter of electricity, its rated output capacity is limited by the length and gauge of the cabling running from the battery to the unit. Use the shortest length and largest diameter cabling (maximum 2 awg ...

  • Page 7: Ac Connection

    7 ac connection to avoid overloading your inverter/charger, be sure to match the power requirements of the equipment you plan to run at any one time (add the total watts) with the continuous output capacity of your inverter/charger (see the specifications section). When figuring the power requiremen...

  • Page 8: Operation

    8 “line” green indicator: if the operating mode switch is set to “auto”, this light will illuminate continuously while connected equipment is receiving continuous ac power from a utility/generator source. If the operating mode switch is set to “charge only”, this light will flash to alert you that t...

  • Page 9: Troubleshooting

    9 try these remedies for common inverter/charger problems before calling for assistance. Call tripp lite customer service at +1 773 869 1234 before returning your unit for service. Troubleshooting symptom problems corrections no ac output unit is not properly connected connect unit to utility power....

  • Page 10: Specifications

    10 specifications model: apsx700hf ac input connection: iec 60320 c14 ac output connection: iec 60320 c13 battery connection: hardwire inverter continuous output capacity (@ 20° c) 700w/700va peak output capacity (instantaneous) 1400w dc input volts (nominal) 12 v dc dc input voltage range 10-15 v d...

  • Page 11: Service

    11 service if you are returning your inverter/charger to tripp lite, please pack it carefully, using the original packing material that came with the unit. Enclose a letter describing the symptoms of the problem. If the inverter/charger is within the warranty period, enclose a copy of your sales rec...

  • Page 12

    12 1111 w. 35th street, chicago, il 60609 usa +1 773 869 1234 • www.Tripplite.Com 200705102 93-2678 200705102 93-2678 apsx700hf om.Qxd 8/30/2007 12:34 pm page 12.