Tripp Lite PS-415-HGULTRA Owner's Manual
Owner's Manual
1111 W. 35th Street, Chicago, IL 60609 USA
www.tripplite.com/support
PS-415-HGULTRA
Power Strip
Patent Number 7,375,939
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
WARNING!
Use of this equipment in life support applications where failure of this equipment can reasonably be
expected to cause the failure of the life support equipment or to significantly affect its safety or
effectiveness is not recommended. Do not use this equipment in the presence of a flammable
anesthetic mixture with air, oxygen or nitrous oxide.
CAUTION!
DO NOT connect to an ungrounded outlet. DO NOT use with extension cords or adapters that
eliminate the connection to ground. The power strip is designed for indoor use only. Install the power
strip away from heat emitting appliances such as radiators or heat registers. Do not install where
excessive moisture or other conductive contaminants are present. Never install electrical wiring during
a lightning storm.
AUTOMATIC OPERATION!
The power strip includes a ground detection circuit with LED for added safety. When the power strip
is plugged into a wall outlet, it detects whether a proper ground is present. If a proper ground is
detected, the green LED illuminates and AC power is routed to the output receptacles. If a proper
ground is not detected, the LED does not illuminate and AC power is not routed to the output
receptacles. The power strip will distribute AC power only when connected to a properly grounded AC
outlet.
Installation
1) Connect Your Power Strip to Your AC Power Line
Plug the power cord into a utility outlet. The power strip’s power cord should only be connected to a
standard 3-wire grounded 120V AC 60 Hz outlet.
2) Connect AC Equipment to Your Power Strip
Plug the AC power cords of your equipment into your power strip. Do not use extension cords or
adapters that eliminate the connection to ground. DO NOT OVERLOAD your power strip. Each outlet
can handle a load of up to the model’s amp rating, but do not exceed a total load of more than the
model’s amp rating for all outlets. If the circuit breaker trips, outlets will cease to provide power.
Reduce the load on the power strip down to your unit’s amp rating by unplugging excess equipment,
then depress the circuit breaker button to reset and restore power.
W
arranty
Registration:
register
online
toda
y f
or
a
chance
to
win
a
FREE
Tr
ipp
Lite
product—www
.tr
ipplite
.com/
warranty
201009029 • 932535-EN
201009029 93-2535.indd 1
9/10/2010 4:16:34 PM