Owner’s manual 1111 w. 35th street chicago, il 60609 usa customer support: (773) 869-1234 • www.Tripplite.Com important safety instructions 2 mounting 3 quick installation 5 basic operation 7 storage and service 11 español copyright ©2004 tripp lite. All rights reserved. Smartpro ® is a registered t...
2 important safety instructions save these instructions this manual contains important instructions that should be followed during the installation, operation and storage of all tripp lite ups systems. Failure to heed these warnings will void your warranty. Ups location warnings • use caution when l...
3 mounting (rack) mount your equipment in either a 4-post or 2-post rack or rack enclosure (see next page for 2-post mounting). The user must determine the fitness of hardware and procedures before mounting. If hardware and procedures are not suitable for your application, contact the manufacturer o...
Mounting (rack) continued 2-post (telecom) mounting mount 1u ups models in 2-post racks with user-supplied hardware following the procedure below. If you mount 2u ups models in 2-post racks, they require the addition of a tripp lite 2-post rackmount installation kit (model: 2postrmkit, sold separate...
5 quick installation unplug computer’s power cord from both ac outlet and computer’s ac input. Insert the female plug of com- puter’s cord into ups’s ac input. Insert the male plug of computer’s cord into ac outlet.* note! After you plug the ups into a live ac outlet, the ups will automatically char...
Optional installation these connections are optional. Your ups will function properly without these connections. Note: smx3000xlrt2u shown in all diagrams. Usb and rs-232 serial communications (all models) use the included usb cable (see ) and/or db9 serial cable (see ) to connect the communication ...
7 “power” button • to turn the ups on: with the ups plugged into a live ac wall outlet*, press and hold the power button for one second.** release the button. If utility power is absent, you can “cold-start” the ups (i.E.: turn it on and supply power for a limited time from its batteries***) by pres...
Basic operation continued indicator lights (front panel) all indicator light descriptions apply when the ups is plugged into a wall outlet and turned on. “power” led: this green led lights continuously when the ups is on and supplying connected equipment with ac power from a utility source. The led ...
9 basic operation continued other ups features (rear panel) ac receptacles: your ups features iec320-c13 outlets, and select models also feature iec320-c19 outlets. These output receptacles provide your con- nected equipment with ac line power during normal operation and battery power during blackou...
Basic operation continued accessory slot: remove the small cover panel from this slot to install optional accessories to remotely monitor and control your ups. Refer to your accessory’s manual for installation instructions. Contact tripp lite customer support at (773) 869-1234 for more information, ...
11 storage and service storage before storing your ups, turn it completely off: with the ups on and receiving utility power, press and hold the power button for one second (an alarm will beep once briefly after the inter- val has passed); then, unplug the ups from the wall outlet. If you store your ...
12 battery replacement model smx500rt1u smx750rt1u smx1500xlrt2u smx3000xlrt2u series # agsmx500rt1u agsm751srm1u agsm152drti2u agsm4878 input nominal voltage/frequency: 230vac/50/60hz 230vac50/60hz 230vac50/60hz 230vac50/60hz suggested circuit: 10 amp 10 amp 10 amp 20 amp output capacity (va/watts)...
1111 w. 35th street, chicago, il 60609 usa 773.869.1234 (usa) • 773.869.1212 (international) www.Tripplite.Com.
