µ-Dimension ADI-12W6 Owner's Manual - Installation
9
Form
122039
Installation
5.1 Tools for Installation:
Tools required for installation: Connectors (butt type and insulated), drill, Crimpers (for
insulated and non-insulated connectors), volt meter with probes, electrical tape, #2
Phillips screwdriver, wire cutters, wire strippers, cable ties, tape measure.
5.2 System Components:
Picture
Model and Description
Qty.
Inverter model: 12W6, 12W8
Options: B3, F3, R, R3 & T
1
141287-1 LED Remote Control/Status panel assembly.
1
611446-XX Remote inverter control panel flat cable.
XX = Cable length in feet.
1
5.3 Mounting the inverter:
5.3.1
Inverter Mounting
The inverter mounting location should provide adequate ventilation and
clearance to maintain room temperature during operation. At least 1/2 inch of
clearance is required on all sides.
• Locate a suitable, secure vertical or horizontal mounting surface as close to the
batteries as possible without being in the same airtight compartment.
• If mounting the inverter on a vertical surface, it is recommended that the front panel
be pointing down whenever possible.
• Locate the mounting holes on the chassis flanges and fasten them using ¼ inch
diameter screws to secure the inverter. See figure 3.
5.3.2 Chassis Bonding Lug:
Connect the bonding lug located at the right side of
the inverter chassis to the earth grounding system using an 8-gauge copper wire.
5.3.3 Remote Control Panel Mounting:
The remote control panel must be
mounted in a convenient, visible and accessible location. Connect the 8-pin flat phone
type cable connector coming from the inverter module to the receptacle on the rear of
the panel. See figure 4.