µ-Dimension EL-MINI4 User Manual - page 3
CHI
CH2
CH4
CH2
POWER
+ -
- +
HPF
HI-INPUT
FULL
CH3
CH4
+ -
- +
HI-INPUT
INPUT
GAIN
MIN MAX
MIN MAX
GAIN
HPF
FULL
CH3
CHI
-2-
-3-
Precautions
Before you drill or cut any holes, investigate your car's layout very carefully. Take care when
you work near the gas tank, fuel lines, hydraulic lines and electrical wiring.
Do not operate the amplifier when it is not mounted. Attach all audio system components
securely within the automobile to prevent damage, especially in case of am accident.
Do not mount this amplifier so that the wire connections are unprotected or in a pinched
condition, or likely to be damaged by nearby objects.
Before making or breaking power connections in your system, disconnect the vehicle
battery, Confirm that your head unit or other equipment is turned off while connecting the
input jacks and speaker terminals.
If you need to replace the power fuse, replace it only with a fuse identical to that supplied
with the system, using a fuse of different type or rating may result in damage to your
system which isn't covered by the manufacturer's warranty.
Four Channel Amplifiers:
CHASSIS GROUND
1 CHANNEL(+)
1 CHANNEL(-)
2 CHANNEL(-)
2 CHANNEL(+)
3 CHANNEL(+)
3 CHANNEL(-)
CHASSIS GROUND
4 CHANNEL(-)
4 CHANNEL(+)
Four Channel Amplifiers:
FRONT
INPUT
REAR
INPUT
From OUTPUT
of HEAD UNIT
Electrical Wiring
When making electrical connections to the amplifier, please observe the following;
Wire the amplifier directly to the car battery.
For the ground connection, use the shortest possible wire to a good chassis ground point.
Wire the Remote connection to the remote turn-on lead of your equalizer or head unit, in
some cases this may be the power antenna lead of the head unit.
Fuses
Fuses protect both the amplifier and the electrical system lf your vehicle,
Mounting the Amplifier
Mark the location for the mounting screw holes by positioning the amplifier where you
wish to install it and use a scribe (or one of the mounting screws)inserted in each mounting
hole to mark the mounting surface, If the mounting surface is carpeted, measure the hole
centers and mark with a felt tip pen.
Drill pilot holes in the mounting surface for the mounting screws and insert the mounting
screws into these holes. Tighten them securely.
Note: Be sure to take note of any wires, lines or other devices in your vehicle which may
be located behind any mounting surface!
CHI
CH2
CH4
CH2
POWER
+ -
- +
HPF
HI-INPUT
FULL
CH3
CH4
+ -
- +
HI-INPUT
INPUT
GAIN
MIN MAX
MIN
MAX
GAIN
HPF
FULL
CH3
CHI