Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2007 u-line corporation 01/2007 2175bevs beverage center and 2175bevol beverage center with overlay installation guide.
2175bevs/2175bevol beverage center www.U-lineservice.Com 2 01/2007 contents exterior cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 cut-out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 product dimensions . . . . . . . . . . . . . . . . . . . . . . . . . ...
01/2007 3 www.U-lineservice.Com 2175bev/2175bevol beverage center general precautions use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: warning shock hazard — electrical grounding required. • keep the unit unplugged t...
2175bevs/2175bevol beverage center www.U-lineservice.Com 4 01/2007 after all the protective coating has been removed from the unit/door, clean all stainless steel surfaces with claire stainless steel polish and cleaner or comparable product or a mild detergent and warm water solution and soft cloth....
01/2007 5 www.U-lineservice.Com 2175bev/2175bevol beverage center product dimensions please note that the unit has adjustable feet that can add one additional inch to height during leveling or to match adjacent cabinets (see figure 29 on page 14). Door swing/clearances information wood overlay units...
2175bevs/2175bevol beverage center www.U-lineservice.Com 6 01/2007 side-by-side installation instructions for a complete refreshment center, install your 2175bevs or 2175bevol unit beside a u-line refrigerator, ice maker or combo model (see figure 4 for typical cut-out). Note that each side-by-side ...
01/2007 7 www.U-lineservice.Com 2175bev/2175bevol beverage center to insert a rack in the cabinet: 1. Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops. 2. Before reloading ...
2175bevs/2175bevol beverage center www.U-lineservice.Com 8 01/2007 final finish-only application: 1. Remove all screws securing wood trim to interior components, and remove the trim. 2. Lightly scruff sand the wood trim with 280 or finer grit sandpaper. 3. Remove sanding dust with a clean, dry cloth...
01/2007 9 www.U-lineservice.Com 2175bev/2175bevol beverage center 5. If door has not been removed from cardboard packaging, carefully cut tape and remove from cardboard first. With bottom of door facing up, remove pivot plate (2 screws), flip over, and remount on opposite side of door (see figure 11...
2175bevs/2175bevol beverage center www.U-lineservice.Com 10 01/2007 3. Create a relief for pivot plate by cutting notch in top corner and coinciding back corner of overlay frame. Refer to figure 15 for exact specifications. Route notch in top corner of overlay frame as shown (see top and side views)...
01/2007 11 www.U-lineservice.Com 2175bev/2175bevol beverage center applying foam tape to overlay frame (if required) 1. Cut foam tape into four pieces, two pieces the width of the overlay frame and two pieces the height of the overlay frame. 2. Remove the adhesive protection strip from one piece of ...
2175bevs/2175bevol beverage center www.U-lineservice.Com 12 01/2007 7. Starting at the corners and working toward the center, push the door gasket back into place. Make sure gasket is seated on all four sides. Installing the door important pivot posts must be clean. Closers must also be clean and gr...
01/2007 13 www.U-lineservice.Com 2175bev/2175bevol beverage center 3. See figure 25. If the top far edge of the door needs to move up, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move down, move the hinge plate toward the inside ...
2175bevs/2175bevol beverage center www.U-lineservice.Com 14 01/2007 leveling information note: it is recommended that the unit is level. 1. Use a level to check the levelness of the beverage center from front to back and from side to side. Level should be placed along top edge and side edge as shown...
01/2007 15 www.U-lineservice.Com 2175bev/2175bevol beverage center initial start-up the unit is shipped with the control preset. No adjustments should be necessary at this time. For information about adjusting the temperature control, see the use and care guide. Start-up troubleshooting problem q: u...
?2007 u-line corporation publication no. 30180e 01/2007 rev. A u-line corporation, located in milwaukee, wi, is a family operated manufacturer of built-in undercounter icemakers, combo ® icemaker/refrigerators, wine captain ® wine storage units, refrigerators, refrigerated drawers and refrigerator/f...
