U-Line ADA151M Use And Care Manual

Other manuals for ADA151M: Install Manual, Features And Specifications

Summary of ADA151M

  • Page 1

    ® combo ® models & manual defrost ice makers co29 co1175 use and care guide ada15im bi95 bi2115 bi98 u-line.Com the built-in undercounter leader since 1962 sp18.

  • Page 2

    Introduction to u-line for product assistance, call 1-800-779-2547 milwaukee, wi u.S.A. Serial/serie: model/modele: high side design pressure 300 psi low side design pressure 140 psi refrigerator and/ btl listed 674r or freezer household u c l r us www.U-line.Com 1 2 introduction congratulations on ...

  • Page 3

    U-line use and care table of contents 1 i - introduction .................................................................................................................................................................I read and save this use and care guide. ............................................

  • Page 4

    1 precautions important important • please read all instructions before installing, operating, or servicing the appliance. • proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation begins. U-line ...

  • Page 5

    4 u-line combo model and ice makerproduct features 4 product features ice makers feature: high ice production and storage. Ada15im, bi2115 and bi98 models produce up to 25 pounds of ice per day and store 25 pounds. Bi95 and sp18 models produce up to 23 pounds of ice per day and store 12 pounds. Comb...

  • Page 6

    U-line product operation 5 off on 1 product operation to turn the unit on or off: press the rocker switch located below the temperature control dial in the center of the grille(2), inside the door on the front panel, or behind the grille. Important important on ice maker equipped units, it is possib...

  • Page 7

    6 u-line product operation to check the actual product temperature in the unit. 1. Partially fill a plastic (nonbreakable) bottle with water. 2. Insert an accurate thermometer. 3. Tighten the bottle cap securely. 4. Place the bottle in the desired area for 24 hours. 5. Avoid opening the unit during ...

  • Page 8

    9 u-line ice maker off on 2 1 6 ice maker ice maker adjustment ice cube thickness adjustment. Interval - as required on ice maker equipped models, adjust the cube size by changing water amount injected into the ice maker assembly as follows: to turn off ice production: raise the bin arm into an upri...

  • Page 9

    U-line combo® models and ice makers maintenance 10 1 7 maintenance for models with adjustable leveling feet: 1. Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1). 2. If the unit is not level, rotate the ...

  • Page 10

    11 u-line combo® models and ice makers maintenance 1 2 4 removing and installing door shelves for models equipped with door shelves: to remove the door shelf: 1. Grasp shelf in center, and lift until the shelf notches (1) clear the pins (2). 2. Carefully pull the shelf away from the door. To install...

  • Page 11

    15 u-line standard door alignment and reversal 9 standard doors door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. Important important properly ...

  • Page 12

    U-line standrd door alignment and reversal 16 install bottom hinge: 1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove the pivot screw from the hinge. Turn the plate over and reinstall the screw. 2. Align hinge outer edge with cabinet...

  • Page 13

    U-line self closing doors 10 door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. Important important • properly aligned, the door’s gasket should...

  • Page 14

    11 u-line self closing doors reversing black or white doors • the hinge hardware will be removed and reinstalled on the opposite side of the cabinet. • the top hinge hardware will be reinstalled on the bottom of the opposite side of the cabinet. • the bottom hinge hardware will be reinstalled on the...

  • Page 15

    U-line self closing doors 12 remove preexisting bottom hinge. 1. Remove the preexisting bottom hinge (three screws) (2). Reinstall hinge to top opposite. 1. Install the hinge just removed from the bottom to the top opposite side of the cabinet (three screws) (2). Reinstall hole plugs. 1. Install pla...

  • Page 16

    13 u-line self closing doors 3. Grasp outer edge of stainless frame and firmly press inside edge of glass in while pulling stainless frame in opposite direction. 4. Unhinge frame from door. Assemble stainless frame 1. Prop frame against solid surface, handle side down and away 2. Insert door, logo f...

  • Page 17

    U-line self closing doors 14 remove existing bottom hinge. 1. Remove the existing bottom hinge (three screws) (2). Reinstall hinge to top opposite. 1. Install the hinge just removed from the bottom to the top opposite side of the cabinet (three screws) (2). Reinstall hole plugs. 1. Install plastic s...

  • Page 18

    14 u-line combo® models and ice makers cleaning to defrost: 1. Disconnect power to the unit. 2. For combo models remove all products from the interior. 3. Remove ice bucket and discard ice. 4. Place towel or other absorbent materialon bottom of ice bin. For combo models also place in bottom of unit....

  • Page 19

    U-line combo® models and ice makerscleaning 15 condensor cleaning interval - every six months to maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be nece...

  • Page 20

    21 u-line combo® models and ice makers service 12 service problem possible cause and remedy interior light does not illuminate. The light bulb may be defective.(see maintenace) light remains on when door is closed. Adjust light actuator bracket on bottom of door. Unit develops frost on internal surf...

  • Page 21: Use and Care Guide

    ® use and care guide ©2009 u-line corporation publication number 30264 07/2012 rev. D u-line.Com the built-in undercounter leader since 1962 building on three generations of innovation for nearly five decades and three generations, u-line continues to be the leader in innovation, quality and value i...