U-Line Combo U-CO1224FB-40A Quick Start Manual - page 9
QUICK START GUIDE
6
u-line.com
Control Operation
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press and the unit will immediately
switch on. To turn the unit off, press and hold for 5
seconds and release.
Up Down
Light Power
Not
Used
Alert
LED
CONTROL FUNCTION GUIDE
FUNCTION
COMMAND
DISPLAY/OPTIONS
ON/OFF
Press
and release
Unit will immediately turn ON or OFF.
Toggle lights
Press
and release to leave interior
light on for 3 hours
Glass door wine and beverage centers only.
Adjust temperature
Press
and release
When the “F” or “C” in the display is flashing, press
to adjust the set point temperature.
View temperature in unit
Press
together and release
The display will flash and then toggle from set point
to temperature in unit.
Toggle between F/C
Hold
for five seconds
The display will change units.
or
or
and
and