U-Line H-1075 Operating Instructions

PAGE 1 OF 4 

0614 IH-1075

π  H-1075

20" VACUUM SEALER

1-800-295-5510

uline.com

SAFEty PRECAUtIONS

to insure safe operation, the operator should be familiar 

with the pinch points and a possible burn hazard near 

the seal jaw area. Warning stickers mark the location of 

these hazards.

Do not wear neckties, jewelry or loose clothing when 

operating the H-1075.

Do not operate, troubleshoot or maintain the H-1075 

under the influence of any drug or alcohol.

Always observe all safety warnings and notices on the 

machine and in this manual.

DO NOt use flammable or toxic cleaning fluids such as 

gasoline, benzene or ether.

CAUTION! Keep hands, fingers and flammable 

objects out of the seal jaw area. If a foreign 

object is caught between the jaws, turn main 

power switch to OFF immediately to prevent 

possible burns.

CONtROlS

MAIN POWER SWItCH – turns power off and on.

FOOt SWItCH –

Controls vacuum cycle and initiates  

seal cycle.

HEAt tIMER – Controls heating time. to increase heat, 

turn heat timer knob clockwise. to decrease, turn knob 

counterclockwise. timer is set in seconds – 10 seconds 

maximum.

COOl tIMER – Controls amount of time that pressure 

bar remains closed for cooling. to increase cool time, 

turn cool timer knob clockwise. to decrease, turn knob 

counterclockwise. timer is calibrated in increments of 

1/10 minute. 

lED INDICAtORS ON HEAt/COOl tIMERS:

• UNlIt: timer is not active. 

• SOlID COlOR: timer is active. 

• FlASHING: timer has timed-out.

OvervIew