U-Line U-CO29B-00 Use And Care Manual

Other manuals for U-CO29B-00: Use & Care Manual, Installation Manual
Manual is about: CLEAR ICE; CLEAR ICE COMBO; ICE COMBO models

Summary of U-CO29B-00

  • Page 1

    ® combo ® models refrigerator / freezer models combo® models use and care guide refrigerator freezer models u-line.Com the built-in undercounter leader since 1962 u-co2175fb-00 u-co29btp-20 u-co2175fs-00 u-co29fb-00 u-co2175fs-01 u-co29fb-98 u-co2175fw-00 u-co29fb-99 u-co29b-00 u-co29fwh-00 u-co29b-...

  • Page 2

    Introduction to u-line for product assistance, call 1-800-779-2547 milwaukee, wi u.S.A. Serial/serie: model/modele: high side design pressure 300 psi low side design pressure 140 psi refrigerator and/ btl listed 674r or freezer household u c l r us www.U-line.Com 1 2 introduction congratulations on ...

  • Page 3

    U-line use and care table of contents 1 - safety precautions .....................................................................................................................................................1 safety alert definitions ..................................................................

  • Page 4

    1 precautions important important • please read all instructions before installing, operating, or servicing the appliance. • proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation begins. U-line ...

  • Page 5

    U-line combo model and ice maker features 2 2 product features combo® model features: built-in or freestanding. Provides custom look when built-in with no additional venting clearance needed on sides, top or rear. Do not obstruct the grille. Ice making and refrigeration in one unit. Provides both ic...

  • Page 6

    3 u-line product operation control systems a portion of models covered in this guide use an electronic touch control while others use a manual control system. See the table below to identify your model and equipped control system.Users with models using manual control should reference “product opera...

  • Page 7

    U-line product operation 4 checking product temperature to check the actual product temperature in the unit. 1. Partially fill a plastic (nonbreakable) bottle with water. 2. Insert an accurate thermometer. 3. Tighten the bottle cap securely. 4. Place the bottle in the desired area for 24 hours. 5. A...

  • Page 8

    5 u-line product operation electronic control quick guide task touch touch display comment turn on/off hold 10 seconds release when °f flashes. Or adjust temperature or touch and release or touch to change temperature °f flashes after first touch, set-point saved after 5 seconds of inactivity and °f...

  • Page 9

    U-line product operation 6 off on 4 product operation manual control to turn the unit on or off: depending on model, a rocker switch will be locate below the temperature control dial in the center of the grille(2), inside the door on the front panel, or behind the grille. To toggle the power state s...

  • Page 10

    7 u-line product operation to check the actual product temperature in the unit. 1. Partially fill a plastic (nonbreakable) bottle with water. 2. Insert an accurate thermometer. 3. Tighten the bottle cap securely. 4. Place the bottle in the desired area for 24 hours. 5. Avoid opening the unit during ...

  • Page 11

    U-line food storage 8 5 food storage drawers the drawers should only be removed for servicing by a trained and certified repair personal. Top storage bin grasp the bin handle and slide backward to access the contents below. The bin may be completely removed for cleaning once it is slid forward, maki...

  • Page 12

    9 u-line ice maker off on 2 1 6 ice maker ice maker adjustment ice cube thickness adjustment. Interval - as required on ice maker equipped models, adjust the cube size by changing water amount injected into the ice maker assembly as follows: to turn off ice production: raise the bin arm into an upri...

  • Page 13

    U-line combo® models and ice makers maintenance 10 leveling important important unit must be level, for proper door and ice maker (if equipped) operation. For models with adjustable leveling feet: 1. Use a level to check the levelness of the unit from front to back and from side to side. Place the l...

  • Page 14

    11 u-line combo® models and ice makers maintenance removing and installing grille warning disconnect electric power to the unit before removing the grille. Warning do not touch the condenser fins(4). The condenser fins are sharp and can be easily damaged. Removing the grille. 1. Disconnect power to ...

  • Page 15

    U-line self closing doors 12 door systems a portion of models covered in this guide use the “self closing” door system while others use the standard door system. See the table below to help identify which door system your model is equipped with. Standard doors should reference “standard doors” on pa...

  • Page 16

    13 u-line self closing doors door reversability location of the unit may make it desirable to mount the door on the opposite side of the cabinet. Many doors are reversible. See table below. Reversing black or white doors • the hinge hardware will be removed and reinstalled on the opposite side of th...

  • Page 17

    U-line self closing doors 14 prepare door for reinstallation. 1. Remove plastic hole plug from top of door handle and reinstall on opposite side. 2. With bottom of door facing up, remove pivot plate (5) (two screws). 3. Flip over and install pivot plate on opposite side of door. Ensure notch in plat...

  • Page 18

    15 u-line standard door alignment and reversal 9 standard doors door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. Important important properly ...

  • Page 19

    U-line standrd door alignment and reversal 16 install bottom hinge: 1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove the pivot screw from the hinge. Turn the plate over and reinstall the screw. 2. Align hinge outer edge with cabinet...

  • Page 20

    17 u-line drawer alignment checking drawer alignment the unit’s drawers are aligned at the factory before shipment. However, their alignment could have been disturbed during shipment or during overlay panel installation. Check each drawer to confirm that it is aligned: • side-to-side — when viewed f...

  • Page 21

    U-line drawer alignment 18 minor adjustment: note: the mounting holes on the slide are slightly larger than the screws’ diameter. 1. Loosen one slide’s mounting screws. 2. Level the slide. 3. Retighten the screws. 4. Repeat procedure for the other slide. Severe adjustment: note: the slides have extr...

  • Page 22

    19 u-line combo® models and ice makers cleaning to defrost: 1. Disconnect power to the unit. 2. For combo models remove all products from the interior. 3. Remove ice bucket and discard ice. 4. Place towel or other absorbent material on bottom of ice bin. For combo models, also place in bottom of uni...

  • Page 23

    U-line combo® models and ice makerscleaning 20 condensor cleaning interval - every three months to maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be ne...

  • Page 24

    21 u-line combo® models and ice makers service 12 service problem possible cause and remedy interior light does not illuminate. The light bulb may be defective.(see maintenace) light remains on when door is closed. Adjust light actuator bracket on bottom of door. Unit develops frost on internal surf...

  • Page 25: Use and Care Guide

    ® use and care guide ©2009 u-line corporation publication number 30265 07/2012 rev e u-line.Com the built-in undercounter leader since 1962 building on three generations of innovation for nearly five decades and three generations, u-line continues to be the leader in innovation, quality and value in...