- DL manuals
- U-Line
- Refrigerator
- U29RB00A
- User Manual & Service Manual
U-Line U29RB00A User Manual & Service Manual - page 18
USER GUIDE
First Use 1
u-line.com
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
First Use
All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product. As warm
air rises, the temperature inside the unit tends
to be slightly warmer at the top and slightly
cooler at the bottom.
To turn the unit on or off:
Press the rocker switch located below the temperature
control dial in the center of the grille.
CONTROL DIAL
The control dial sets a single continuous temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 3 or 4 set point,
is approximately 38°F (3°C). The set point temperature is
a gauge for further temperature adjustments.
OFF
ON
Summary of U29RB00A
Page 1
User guide & service manual safety • installation & integration • operating instructions • maintenance • service ada series • 29r • 21" solid door refrigerator right product. Right place. Right temperature. Since 1962..
Page 2
User guide u-line.Com contents safety • installation & integration • operating instructions • maintenance • service intro safety safety and warning disposal and recycling installation environmental requirements electrical cutout dimensions product dimensions side by side installation general install...
Page 3
User guide introduction 1 u-line.Com welcome to u-line congratulations on your u-line purchase. Your product comes from a company with over five decades of premium modular ice making, refrigeration, and wine preservation experience. U-line continues to be the american leader, delivering versatility ...
Page 4
User guide safety and warning 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service safety and warning notice please read all instructions before installing, operating, or servicing the appliance. Use this appliance for its intended purpose only and follow...
Page 5
User guide disposal and recycling 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service disposal and recycling danger ! Risk of child entrapment. Before you throw away your old refrigerator or freezer, take off the doors and leave shelves in place so child...
Page 6
User guide environmental requirements 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service environmental requirements this model is intended for indoor/interior applications only and is not to be used in installations that are open/ exposed to natural ele...
Page 7
User guide electrical 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service electrical warning ! Shock hazard — electrical grounding required. Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected. Never rem...
Page 8
User guide cutout dimensions 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service cutout dimensions prepare site your u-line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional...
Page 9
User guide product dimensions 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service product dimensions 28 1/2 " (724 mm) 20 7/8 " (530 mm) 4 9/16 " (116 mm) 23 " (584 mm).
Page 10
User guide side-by-side installation 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service side-by-side installation two units may be installed side-by-side. Cutout width for a side-by-side installation is the cutout dimension of a single unit times two. N...
Page 11
User guide general installation 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service general installation leveling information notice because these units do not have leveling legs, it is extremely important that they sit on a level surface. Use a level to...
Page 12
User guide integrated panel dimensions 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service integrated panel dimensions insert custom 1/4'' thick door panel insert panel preparation a custom door panel may be inserted into the door frame. Custom door pane...
Page 13
User guide integrated panel installation 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service integrated panel installation this model accepts a 1/4" insert panel. Insert panel installation install the insert as follows: caution ! Use care when handling t...
Page 14
User guide grille - plinth installation 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service grille - plinth installation removing and installing grille warning ! Disconnect electric power to the unit before removing the grille. When using the unit, the g...
Page 15
User guide door swing 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service door swing all units have a zero clearance for the door to open 90°. U-line recommends a minimum door clearance of 1/4" (6 mm) to accommodate the handle if the unit is installed ne...
Page 16
User guide door adjustments 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service door adjustments checking door alignment the unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment. Notice p...
Page 17
User guide door adjustments 2 u-line.Com safety • installation & integration • operating instructions • maintenance • service 6. Install hinge on opposite side at bottom of cabinet. Align hinge outer edge with cabinet before tightening screws. 7. Relocate plastic spacer/bushing on top and bottom of ...
Page 18
User guide first use 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service first use all u-line controls are preset at the factory. Initial startup requires no adjustments. Notice u-line recommends allowing the unit to run overnight before loading with pro...
Page 19
User guide airflow and product loading 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service airflow and product loading notice the unit requires proper airflow to perform at its highest efficiency. Do not block the front grille, or the unit will not perfo...
Page 20
User guide interior shelves 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service interior shelves removing and installing interior shelves for models equipped with glass shelves having shelf supports, remove the shelves as follows: 1. Open door completely...
Page 21
User guide door shelves 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service door shelves removing and installing door shelves to remove the door shelf: 1. Grasp shelf in center, and lift until the shelf notches (1) clear the pins (2). 2. Carefully pull t...
Page 22
User guide cleaning 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service cleaning exterior cleaning vinyl clad (black or white) clean surfaces with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge ...
Page 23
User guide cleaning 2 u-line.Com safety • installation & integration • operating instructions • maintenance • service high ambient temperature and excessive humidity can also produce frost. Caution ! Do not use an ice pick or other sharp instrument to help speed up defrosting. These instruments can ...
Page 24
User guide cleaning condenser 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service cleaning condenser interval - every six months to maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser when necessary. Depe...
Page 25
User guide extended non-use 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service extended non-use vacation/holiday, prolonged shutdown the following steps are recommended for periods of extended non-use: 1. Remove all consumable content from the unit. 2. ...
Page 26
User guide troubleshooting 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service troubleshooting before calling for service if you think your u-line product is malfunctioning, read the control operation section to clearly understand the function of the con...
Page 27
User guide troubleshooting 2 u-line.Com safety • installation & integration • operating instructions • maintenance • service checking product temperature to check the actual product temperature in the unit: 1. Partially fill a plastic (nonbreakable) bottle with water. 2. Insert an accurate thermomet...
Page 28
User guide u-line.Com safety • installation & integration • operating instructions • maintenance • service u-line corporation (u-line) limited warranty one year limited warranty for one year from the date of original purchase, this u-line product warranty covers all parts and labor to repair or repl...
Page 29
User guide wire diagram 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service wire diagram 42341_a wiring diagram ground: green or green w/ yellow 115 volt plug 220-240 volt plug contr ol see compressor dia grams blue black-hot (smooth) black-neutral (ribb...
Page 30
User guide product liability 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service product liability field service technicians are authorized to make an initial assessment in the event of reported damages. If there are any questions about the process invol...
Page 31
User guide warranty claims 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service warranty claims the following information defines the parameters for filing a warranty claim: • valid serial number needed • valid model number needed • narda (or equivalent) ...
Page 32
U-29rb-00a item description u-line p/n 1 back panel 80-54505-00 2 bottle retainer, long 80-54530-00 3 bottle retainer, short 80-54533-00 4 compressor electricals only 80-54149-00 5 compressor w/electricals 80-54150-00 6 condenser assembly 80-54521-00 7 condenser fan w/screws 80-54014-00 8 control as...
Page 33
User guide ordering replacement parts 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service ordering replacement parts if you have a purchasing account, please utilize our service website to order parts. Orders may also be placed by fax or phone. See our c...
Page 34
User guide system diagnosis guide 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service system diagnosis guide refrigeration system diagnosis guide system condition suction pressure suction line compressor discharge condenser capillary tube evaporator watt...
Page 35
User guide compressor specifications 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service compressor specifications danger ! Electrocution can cause death or serious injury. Burns from hot or cold surfaces can cause serious injury. Take precautions when s...
Page 36
User guide troubleshooting - extended 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service troubleshooting - extended specific errors & issues caution ! Never attempt to repair or perform maintenance on the unit until the main electrical power has been di...
Page 37
User guide troubleshooting - extended 2 u-line.Com safety • installation & integration • operating instructions • maintenance • service ice maker diagnosis flow chart does the unit refrigerate? Sealed system leak electrical failure compressor failure fan motor failure defrost system failure low volt...
Page 38
User guide troubleshooting - extended 3 u-line.Com safety • installation & integration • operating instructions • maintenance • service product temperature causes which affect the internal temperatures of the cabinet include: • temperature setting. • ambient temperature where installed. • installati...
Page 39
User guide troubleshooting - extended 4 u-line.Com safety • installation & integration • operating instructions • maintenance • service refrigeration system diagnosis guide ice maker operating cycles freeze cycle temperature control terminals 2 and 3 are closed. Power to the compressor. Power to the...
Page 40
User guide troubleshooting - extended 5 u-line.Com safety • installation & integration • operating instructions • maintenance • service harvest-1 cycle temperature control terminals 2 and 3 are open - 2 and 1 close. No power to the compressor or condenser fan. If bin arm is down, power goes through ...
Page 41
User guide troubleshooting - extended 6 u-line.Com safety • installation & integration • operating instructions • maintenance • service harvest-2 cycle ice maker ejector blades reach approximately 2:00 position and cam depresses the hold switch. Power goes through the hold switch to the ice maker mo...
Page 42
User guide troubleshooting - extended 7 u-line.Com safety • installation & integration • operating instructions • maintenance • service water fill cycle ice maker ejector blades reach approximately 10:00 position and cam depresses the water fill switch. Power to the water valve. Ice maker mold fills...
Page 43
User guide troubleshooting - extended 8 u-line.Com safety • installation & integration • operating instructions • maintenance • service temperature control specifications these temperature controls are double throw, single pole controls. The sensing tube is inserted into the ice maker mold and sense...
Page 44
User guide troubleshooting - extended 9 u-line.Com safety • installation & integration • operating instructions • maintenance • service limit switch specifications normally closed bi-metal switch open temperature: 104°f close temperature: 83°f the function of this switch is to open in the event of a...
Page 45
User guide troubleshooting - extended 10 u-line.Com safety • installation & integration • operating instructions • maintenance • service frost free refrigeration cooling mode bypass solenoid closed. Evaporator fan operating. Refrigerant flows through capillary tubes. Normal vapor/compression cycle r...
Page 46
User guide troubleshooting - extended 11 u-line.Com safety • installation & integration • operating instructions • maintenance • service air flow in at evaporator blade air flow out at evaporator outlet air passes though fin tube evaporator condensate drains down past the evaporator, into drain pan,...
Page 47
User guide defrost 1 u-line.Com safety • installation & integration • operating instructions • maintenance • service defrost these units are automatic (cycle) defrost unit will defrost itself when the control/sensor is satisfied of internal temperatures. Defrost mode ends when control/sensor asks fo...