Summary of LanDisk
Page 1
1.
Page 2: Landisk Advanced User Guide
2 landisk advanced user guide v1.0 (2005/2/18) i 1.Disk utility .………………………………………….……………………….3 1-1 set cluster unit…………………………………..…………………………………………..………3 1-2 scandisk……………………………………………..…………………………………….………….4 2. Network share .…………………………………………………………….4 2-1 smb configuration…………………………….………………………………………………...
Page 3: 1. Disk Utility
3 1. Disk utility set cluster unit: note: landisk needs hdd with ultradma supported. *hdd above 20gb has supported ultradma generally; if the hdd is under 20gb, please check if it has ultradma supported. *each file size is 4gb limited due to fat32 format. Landisk fat32 format setting: default cluste...
Page 4: 2. Network Share
4 scandisk here you can check if there is error on your hdd, press “start” and the dialog box will show as below, press ok to start the hd checking. 2. Network share 2-1 smb configuration hostname 以及 以及 以及 以及 group name set up your hostname and work group here smb share list set the folder you like ...
Page 5
5 2-2 ftp configurations here you can set ftp functions, status and user’s authority, please check the image below..
Page 6
6 ftp status enable / disable ftp function. Allow anonymous if you allow anonymous login, and the authority after anonymous login, home directory is the folder will be access by anonymous login. Ftp acoount list presses “ add/modify “ to set the accounts that you allow accessing landisk, and definin...
Page 7
7 after “add/modify”, you will see the accounts list as below, ro=read only, rw= read and write, and you can also use “en/disable” to control certain account to access ftp..
Page 8: 3.System
8 3.System here you can set the administrator password, time zone, ip configuration, dhcp service. 3-1 password id, password setting for administrator. 3-2 time zone check enable or disable to define if you like to use sntp (simple network time protocol) time server: define ntp server. Time zone: de...
Page 9
9 3-3 ip config here you can set the ip configuration (automatic ip or static ip) as below: note: the hub or router you connect with landisk must has dhcp service if you choose “automatic ip”, if your device has no dhcp service, the default ip will be “169.254.0.1”, the device which was in that ip a...
Page 10
10 3-4 dhcps landisk has built in dhcp service. You can start the dhcp service here and landisk will turn it self into a dhcp server. Dhcp server configuration set the dhcp configuration as below: note: if the hub or router connected to landisk has dhcp, the landisk will prevent the setting..
Page 11
11 dhcp client list if you want to point a certain ip address for certain mac address (fixed mapping), please press “fix mapping table” to set up as below: note: fixed mapping will be functional only when the dhcp service was provided by landisk it self..
Page 12: 4.Mantenance
12 4.Mantenance 4-1 firmware upload here you can update the new firmware for your landisk, please follow the steps below: 1. Choose the “firmware***.Bin” to update 2. Press “upload”, the dialog will show the warning message as below. Press “ok” to proceed..
Page 13: 5.Faq
13 please do not close the window or turn the power off, until the success message dialog has been shown as below: 3.Press “restart” and wait about 30 seconds then refresh this page by pressing “refresh button” on ie browser, or reboot the landisk. 4-2 factory defaults you can press “reset” here the...