V.link VL2-DVD800 Manual - page 5
Version 28.07.2015
VL2-DVD800
P
age
5
1.3.3. Vehicle selection (dip 7-8)
Choose the vehicle/navigation/monitor the interface is to be installed to and set dip 7
through 8 according to the below table.
Vehicle/ Navigation
Dip 7
Dip 8
7“-monitor with resolution 800x480
OFF
OFF
6.5”- monitor with resolution 480x240
OFF
ON
2. Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The interface is installed on the backside of the vehicle’s monitor. The external daughter PCB
is plugged in between the flex cable and the flex cable socket of the monitor panel.
Therefore, the monitor must be removed.