V.link VL2-MBN51 Manual - page 8
Version 12.08.2016
VL2-MBN51
P
a
g
e
8
2.3.
Connecting video-interface and CAN-box
The CAN-bus box reads digital signals from the CAN-bus and converts them for the video-
interface. ACC +12V max. 0.5A (red of 6pin) and reverse gear +12V max. 0.5A (green of 6pin)
constant signal. Additionally there is a data exchange, e.g. for steering wheel position for
driving path lines (green-red drilled cable from 6pin to 8pin cable).
Connect black female 10pin Micro-Fit connector of the Quadlock harness to the male
10pin Micro-Fit connector of the CAN-box.
Note: Check LEDs on CAN-box after reconnecting the battery, two must be on.
Connect white female 6pin Molex connector of the 6pin to 8pin cable to the male
6pin Molex connector of the video-interface.
Connect black female 8pin Micro-Fit connector of the 6pin to 8pin cable to male 8pin
Micro-Fit connector of the CAN-box.
Note: Check LEDs on video-interface after reconnecting the battery, one must be on.
Connect red-green drilled cable of 6pin of 8pin cable to the male 4pin connector of
the video-interface.
Note: The CAN-box is not compatible with all vehicles. If the CAN-box does not deliver ACC
to pin2 of the video-interface or blocks the vehicle CAN, it is possible to install without CAN-
box. In this case see also note in chapter after-market rear-view camera if one is supposed to
be connected.