V-Moda vamp verza User Manual - page 11
verza manual v1.0 11
Listening to Music in iPod/iPhone in VERZA
“
VAMP
”
Mode
1.
Turn on the power by the power switch volume knob and set the toggle switch (2) to "VAMP" position.
2.
Once VERZA and iPod/iPhone are correctly connected (authenticated), the toggle switch LED turns on
red or green.
* If the toggle switch is blinking, iPod/iPhone may not be connected with VERZA at all, or it may not be
correctly connected (authenticated).
In such case, disconnect iPod/iPhone once and reconnect, or turn OFF the power by turning the power
switch volume knob counterclockwise all the way until it clicks, and then turn the power ON again. Refer
to
“
Setting Other Functions
”
for how to turn the power ON/OFF
* If the toggle switch LED does not turn on, the remaining battery of VERZA may be low. In such case,
check the remaining battery and charge as necessary.
Charging iPod/iPhone by the Built-in Battery in VERZA "
Ϟ
+VAMP" Mode
Turn on the power by the power switch volume knob and set the toggle switch (2) to "
Ϟ
+VAMP" position.
Once connected (authentication is completed), iPod/iPhone starts to be charged by built-in battery of VERZA.
MEMO
The battery charging icon appears at the top
right of iPod/ iPhone screen when
iPod/iPhone is correctly being charged.
CAUTION
While charging iPod/iPhone from the built-in
battery, VERZA becomes hot, but this is not a
malfunction.
Also, touching VERZA for a long time may cause low
temperature burn, and therefore avoid charging in
your pocket or in similar situations.