V-Sun V690 User Manual - page 8
first phone number. Press the CALL 2 button, then the terminal will automatically dial the second phone
number. In addition, the terminal may receive all calls by pressing the Receive button and end all calls by
pressing the End button.
Remarks: The automatic receiving function of the terminal. For all calls, if the terminal does not choose to
end or receive within 30s, they can be received automatically.
4.
4.
4.
4. SOS
SOS
SOS
SOS Function
Function
Function
Function
If a ward number (the number in 3 above) is set, when the ward encounters emergency and presses the
SOS button, then the terminal will send alarming information to the center number and dial three ward numbers
in order.
5.
5.
5.
5. Monitoring
Monitoring
Monitoring
Monitoring Function
Function
Function
Function
The ward may send SMS 555 + password to the terminal of the ward; in such case, the ward terminal of
the ward will automatically call back the mobile phone of the guardian and the guardian may listen to the sound
of the surroundings within 10m around the ward.
SMS format: 5550000
Remarks: 0000 is the initial default password and the actual use s subject to the actual password.
6.
6.
6.
6. Regular
Regular
Regular
Regular Upload
Upload
Upload
Upload Interval
Interval
Interval
Interval Setup
Setup
Setup
Setup
The defaulted factory upload interval of this device is 2 minutes for getting the point and 10 minutes for
uploading one piece of positioning information. The user may change such parameter according to actual
demand.
Command format: # command number 730# Sampling interval # Pieces of uploads # User password ##
For example: 730#20#4#0000##
Note: The parameter “20” indicates getting one point every 20s; after getting points accumulatively for 4
times, upload one piece of positioning information with the upload interval as 20*4=80s. The user may change
this parameter as the case may be.
7.
7.
7.
7. Function
Function
Function
Function of
of
of
of Changing
Changing
Changing
Changing Password
Password
Password
Password
Send the SMS
“#770# User new password # User old password ##”
by mobile phone to the terminal
number, after successful sending, the mobile phone with such setup will receive one piece of config ok
response information, as shown in the following figure:
8.
8.
8.
8. Low-Voltage
Low-Voltage
Low-Voltage
Low-Voltage Alarming
Alarming
Alarming
Alarming Function
Function
Function
Function