Dt-dj5a user manual audio phone read this manual carefully before using the product, and keep it well for future use..
1. Parts and functions side view 88 110 20 speaker microphone unlock button talk button unlock 2nd/intercom button indicator tone volume controller talk volume controller speaker send out voice from the visitor. Microphone receive voice from the user. Unlock button press to release the door. Talk bu...
2. Terminal descriptions l2 l1 l1, l2 dip2 dip1 1 2 3 4 5 6 on dip on 1 2 3 l1,l2:bus terminal. Dip1(bit1~6): used to user code setting. Dip2(bit1~3): used to slave monitor address or extended address setting. 3. Unit mounting 1). Fix 2 screws to the wall at a appropriate height; 2). Connect the sys...
4. Operation instructions 5. Setup instructions 1) door release function: when visitor calls from outdoor station, the monitor rings, press talk button to talk with the visitor, then press the unlock button to open the door. If the system connect 2 locks, press unlock 2nd button to open the second d...
5.2 slave address or extended address setting(dip2 to set it) when multi monitors are installed in one apartment, these monitors have to use the same user code setting, and the master/slave mode should be set on the monitor. • bit-1~2 of dip2 are used to slave address or extended address setting. • ...
5.3 ring tone setting 1). There are four groups ring tones to choose for you: 5.2.2 when bit-3 of dip2 set to on, the bit-1~2 of dip2 and bit-1~5 of dip1 are used to extended address setting: 1 2 3 4 5 6 on code=33 1 2 3 on dip2 state dip1 state user code 1 2 3 4 5 6 on code=1 1 2 3 on 1 2 3 4 5 6 o...
2). Press and hold talk button in standby mode to enter the state of ring tone setting, and then each time you press unlock 2nd button to replace a group of ring tones. Four groups ring tones cycle: group1 group2 group3 group4. Press unlock 2nd press unlock 2nd press unlock 2nd press unlock 2nd 3). ...
